Examples of 'ttings' in a sentence
Meaning of "ttings"
Ttings refer to fittings, which are pieces used to connect or join different parts together. This term is often used in construction, plumbing, or mechanical contexts to describe various types of connectors and adapters
How to use "ttings" in a sentence
Basic
Advanced
ttings
Fi xtures and fi ttings of buildings and constructions.
Flow in pipes and valves and fi ttings.
Tighten loose fi ttings or replace parts as required.
Replace any damaged or worn hoses or fi ttings.
Prepare two fi ttings with nuts and clevises.
Grease gun or positioning the hose onto fi ttings.
Install male fi ttings in correct direction.
Excessive pressure can be caused by high pressure loader fi ttings.
Install the fi ttings on the fi n as well.
Bender recovered after a few bends through savings on fi ttings.
Remove inlet fi ttings from inside fi lter sock.
Insert a rubber seal into the threaded fi ttings on each hose.
Leak check all fi ttings before lighting your grill.
Venting should be as direct as possible with a minimum number of pipe fi ttings.
Check that hoses and fi ttings are air tight.
See also
Located in a perfectly connected area with a whole network of new ttings.
Never hold onto the hose or fi ttings during operation.
Check all fi ttings again and correct any leaks and recheck.
Apply liquid to all areas with fi ttings or connections.
Check all the fi ttings by wetting them with soapy water.
The boiler pipes can be connected to the installation by means of compression fi ttings.
Comparison of different valves and fi ttings and their operation.
Check all fi ttings and buckles for signs of worn out parts.
Never attach or remove wand or hose fi ttings while system is pressurized.
Set the nuts and washer on both side of the metal fi ttings.
Make sure hose and fi ttings are tightened and in good condition.
Take care when using pliers or pipe wrenches to tighten plastic fi ttings.
Subdued lighting with light fi ttings concealed behind backrests or lampshades.
Repeat this step until there is no air bubbling from the loosened line fi ttings.
Ensure all tubing and fi ttings are secure and free from leaks.
Do not use Tefl on tape with compression fi ttings.
Check all hoses and fi ttings for chafi ng and fl uid leaks.
ElectrocutionUnit must be installed in a vertical position with the water fi ttings pointing downward.
Glue the next two fi ttings in place before connecting to the power unit.
Pressure loss in pipes, pipe fi ttings and valves.
Air supply hoses and fi ttings before connecting the tool to an air supply.
Use pliers to bend the twelve brass two-hole fi ttings at.
Leak test all valves and fi ttings as described at the beginning of this section.
Attach the cables to the brass three-hole fi ttings at the.
Select the fi ttings and the equipment that best suit your particular bathroom.
The difference is that all the interior fi ttings are in natural blonde aspen.
These fi ttings DO NOT lock together.
Do not use damaged, frayed or deteriorated air hoses and fi ttings.
Do not remove any covers or loosen any fi ttings while the mixer is operating.
Do not use lead-tin solder to join pipes and fi ttings.
Do not remove any covers or loosen any fi ttings whilst the machine is operating.
To reduce the risk of injury, use only low pressure loader fi ttings.
Wrap threads of the hose fi ttings with thread tape before threading into pump C.
Complete piping systems in ductile cast iron, pipe connectors and fi ttings.
It is recommended to control the fi ttings with pre-existing fl ues.
