Examples of 'tubes must' in a sentence
Meaning of "tubes must"
Implies that tubes (objects with hollow cylindrical shapes) have a requirement, obligation, or necessity to fulfill a certain condition or perform a specific action. The phrase indicates that it is imperative for tubes to meet a certain standard, satisfy a particular criteria, or adhere to prescribed guidelines
How to use "tubes must" in a sentence
Basic
Advanced
tubes must
Those tubes must contain the fuel.
Nozzles and suction tubes must not.
Vacuum tubes must be assembledtogether before use.
The loading in the opposite tubes must be equal.
The opposite tubes must be filled up equally.
The compression or other mechanical restriction of the crosssection of connecting tubes must be avoided.
The boiler tubes must be extra strong.
For infertility to occur, both fallopian tubes must be blocked.
Capped tubes must be used for centrifugation.
When used in water the tubes must be liquid-tight.
Both tubes must be of the same diameter.
These plates or these conductive tubes must have a very limited thickness.
All tubes must be cut squarely with no burrs.
The passage section of the tubes must meet feasibility constraints.
Tubes must always be held near the end.
See also
That stuff in them tubes must be worth a bob or two.
Tubes must be kept in a sloping position while being filled.
At many locations the tubes must be cleaned every six weeks.
The tubes must not be cracked or blocked and must be securely attached.
Since this must be satisfied, the number of tubes must be small.
These tubes must be welded to the hanger brackets.
In order to carry out the drawing in continuous operation, the tubes must be jointed.
These types of tubes must be placed in a hospital setting.
In one situation, for example, the patency of the fallopian tubes must be determined.
The vacuum tubes must be assembled together before use.
I am a carpenter . Then your bronchial tubes must be in weak conditions.
The test tubes must have the following dimensions.
Of course, during any particular PCR processing cycle, all tubes must be the same height.
The tubes must stop.
To measure dew points below -40 C, FEP, PTFE or stainless steel tubes must be used.
Coaxial tubes must not be installed for any reason.
Furthermore, the images produced by the three tubes must be perfectly superimposed on the screen.
Flash tubes must only be exchanged by authorized trained personnel.
In production, following rolling, the ready rolled-out tubes must undergo a number of further processing steps.
The tubes must be sent at the beginning of the week.
The flocculation time for the 3 test tubes must not vary more than 0.1 min 6 sec.
The tubes must be clean for efficient transfer of heat.
Nozzles and suction tubes must not reach head level whilst in use.
Tubes must be inflated in the correct sequence to prevent over-inflation.
The flexible vent and outlet tubes must be correctly connected to the tap supplied by.
If tubes must be separated for realignment, storage, etc ., use the following procedure.
The horizontal tubes must be able to resist this pressure.
The tubes must be filled under clean but not necessarily sterile conditions.
The drain and inlet water tubes must be plumbed before connecting to the ice machine.
Blow tubes must be assembled to the power head before use.
The material of the sample tubes must be compatible chemically with the PCR reaction.
Both tubes must be released for the top rail to fold.
Afterwards the anti-tip tubes must be set back to their correct position.
These tubes must be numerous enough to ensure good distribution of the light intensity.
The replacement of neon tubes must be carried out only by an Authorized Service Center.
