Examples of 'type i test' in a sentence
Meaning of "type i test"
In the context of psychological evaluations, 'type i test' refers to a test that measures a specific trait or characteristic of an individual. It is usually used to categorize individuals into different classifications based on their scores or responses
How to use "type i test" in a sentence
Basic
Advanced
type i test
Record of type i test results.
Type i test methods.
Breakdown of the operating cycle used for the type i test.
Type I test checking the average value of tailpipe emissions in a congested urban area.
Vehicles other than the vehicle originally taken are subjected to a single type I test.
Type I test average emissions of gaseous pollutants in a congested urban area after cold start.
Conformity of the vehicle for a type I test shall be checked as follows.
Type I test simulating the average tailpipe emissions after a cold start.
The test cycle for the Type I test consists of up to three parts.
The content by volume of carbon monoxide shall be measured immediately after the Type I test.
Specific requirements on the Type I test verifying the average exhaust emissions after a cold start.
The actual sulphur content of the fuel used for the Type I test shall be reported.
In the Type I test and mandatory emission limit values for.
A measurement at the setting used for the type I test is performed first.
Type I test Simulating the average exhaust emissions after a cold start.
See also
Flow chart for the type I test.
Type I test (checking the average emissions of gaseous pollutants in a congested urban area).
Vehicles with a negligible SOC over a type I test.
Type I test as described in Annex 4a cold start urban and extra urban test.
Operating cycle used for the type I test.
Type I test (verifying the average emission of tailpipe emissions after a cold start).
Rolling circumference of tyres used for the Type I test.
The Type I Test need not be performed for the demonstration of electrical failures short / open circuit.
Checking the conformity of the vehicle for a Type I test.
For these failure modes, a Type I Test need not be performed.
Phases occur under the conditions equivalent to Type I test.
From the start of a Type I test as described in Annex 4a to this Regulation.
D The theoretical distance covered by a vehicle tested under the Type I test in km.
Type I test (Verifying exhaust emissions after a cold start).
For this specific failure mode, the Type I test need not be performed.
For NOVC vehicles, under the same conditions as in the Type I test.
For this specific failure mode, the Type I test must not be performed.
Test 1, Type I test has to be carried out with a fully charged / electrical energy / power storage device.
The test is carried out using the procedure of Type I test as described in Annex 4a.
The Type I test need not be performed for the demonstration of electrical failures (short/open circuit).
In this case, the emissions measured during the regular Type I test may be used.
The emissions results of the Type I test for each part of the test see Annex 11.
Vehicles with a non-negligible SOC over a type I test.
When n > 1, the first Type I test is run cold, and subsequent cycles are hot.
Appendix 1: Operating cycle used for the type I test.
This annex describes the procedure for the Type I test defined in paragraph 5.3.1 . of this Regulation.
That corresponding to the setting for Type I test at 50 km / h.
You'll also be interested in:
Examples of using Test
Show more
Mechanical tensile test prehoistable navigation lights
A test with tripping is compulsory on installation startup
Before the test we had art class
Examples of using Type
Show more
Type designation of the temperature measuring equipment
I expect this type of disrespect from crips
Type designation of the power supply unit
