Examples of 'valve inlet' in a sentence
Meaning of "valve inlet"
Valve inlet refers to the opening or entrance through which a fluid or gas enters a valve. In the context of valve systems, the inlet is the point at which the substance being controlled by the valve flows into it. It is a crucial component that regulates the flow rate and direction of fluids or gases within the system
How to use "valve inlet" in a sentence
Basic
Advanced
valve inlet
Is dependent of valve inlet pressure and temperature of water.
In a preferred embodiment the valve includes a valve inlet.
The valve inlet or supply line may be plugged.
Remove plastic cap from water valve inlet port.
Clean the valve inlet filters.
Insert copper tubing into water valve inlet portD.
The valve inlet filter is obstructed.
Insert copper tubing into water valve inlet port.
Check water valve inlet for sediment and clean if necessary.
Insert copper tubing into water valve inlet portE.
In one embodiment the valve inlet is circular and the valve outlet is elliptical.
Connect brass nut on copper tubing to water valve inlet port.
Remove the clamp screw at valve inlet and spread the clamp open.
The pressure is then vented from the check valve inlet.
Attach the copper tube to the valve inlet using a compression.
See also
Be sure incoming hard water supply is directed to the softener valve inlet port.
A gas admission valve has a valve inlet and a valve outlet.
Check if the hot water supply is turned on and connected to the valve inlet.
Removeplastic cap from water valve inlet and discard cap.
The valve inlet port has a new Venturi taper added to the previous cylindrical inlet port.
Place end of copper tubing into water valve inlet port.
A valve inlet connected to the junction ;.
The methods were tested in a safety valve inlet piping case.
The valve inlet port 18 communicates permanently with the valve chamber 83.
Remove plastic cap from water valve inlet and discard cap.
Fill Valve strainer blocked Clean out strainer on fill valve inlet.
Push the copper tube into water valve inlet as far as it will go.
Slide the compression nut over the sleeve and screw into the water valve inlet port.
Brass nut Water valve inlet port.
When such fluid pressure decreases to a level below the cracking pressure, the valve inlet closes.
Slide ferrule ( sleeve ) into valve inlet and finger tighten compression nut onto valve.
Be sure to direct the incoming hard water supply to the softener valve inlet fitting.
Connect hose to the valve inlet see Figure 3.
Place the end of the copper tubing into the water valve inlet port.
Unscrew plastic cap from water valve inlet ( some models ) and discard cap.
Am is the upstream pressure at the EGR valve inlet.
Push water supply line into water valve inlet as far as it will go1/4 inch.
Am is the upstream temperature at the EGR valve inlet.
The flow control valve inlet 64 may be fluidly coupled to the housing outlet 40.
Unscrew plastic cap from water valve inlet and discard cap.
However, sealing problems remain, notably at the throttle valve inlet.
A gas admission valve may have a valve inlet and a valve outlet.
In this case, the lower opening 34 in the adapter element serves as the valve inlet.
The overflow room is in turn connected with the valve inlet union through connecting openings.
The cistern has a capacity of thirty-two litres and is fed from a conventional float valve inlet 100.
The first member is rigid and defines the valve inlet port and the valve seat.
Expiratory valve inlet 34 communicates with the expiratory valve body 38 located within flow sensor module 36.
The valve seat may be located between the valve inlet and the valve outlet.
Z-valve. The valve inlet and blowing muzzle are installed backwards. Re-install.
Connect the copper tubing water supply to the water valve inlet with a compression nut fitting.
