Examples of 'valve knob' in a sentence
Meaning of "valve knob"
valve knob ~ It refers to a small handle or lever used to control the flow of fluids, gases, or air through a valve
How to use "valve knob" in a sentence
Basic
Advanced
valve knob
Reinstall fuel valve knob in generator housing.
Valve knob clockwise to properly close the valve.
Turn the cylinder valve knob counter.
Gas valve knob difficult to turn.
Use only your hand to turn the gas valve knob.
First open the valve knob regulator to light by match.
Then continue with steam generation by turning the valve knob to the position again.
Turn reel valve knob to adjust backlap reel speed.
Pry off the retaining clip from inside the recessed portion of the valve knob.
Make sure that the valve knob points to the position.
Gas valve knob not pressed down firmly or long enough to heat the thermocouple.
Slowly turning the relief valve knob to PRIME k.
Turn the valve knob clockwise to properly close the valve.
Then return the espresso switch to I and the valve knob to the position.
Push the fuel valve knob through the generator housing to access the petcock.
See also
Once a pilot flame has been established, turn the gas valve knob.
Turn the valve knob to the position and move the espresso switch to the position.
Push the gas control valve knob and turn to OFF.
Allow the pilot to burn approximately 30 seconds before releasing the gas valve knob.
Depress the gas valve knob and hold while lighting and observing the pilot burner.
Turn on the fuel supply by rotating the cylinder valve knob counter-clockwise to full open.
Turn the gas valve knob counterclockwise to the PILOT position.
Turn on the fuel supply by slowly rotating the cylinder valve knob counter-clockwise to full.
Turn heater gas valve knob and gas tank valve to OFF position.
I Figure 23 below shows the rear view of the relief valve knob.
Turn gas valve knob CLOCKWISE to.
Back of PRIME / SPRAY valve knob.
Turn gas valve knob clockwise to OFF position.
The pattern size can be reduced by turning pattern valve knob ( 21 ) clockwise.
Turn the cylinder valve knob one turn counter-clockwise.
Keep the valve knob depressed for at least 30 seconds after lighting the burner.
After the frothing operation, turn the valve knob to the position and remove the jug.
ABS valve knob and PA cap, chrome-plated.
When burner stays lit, turn gas valve knob counterclockwise to desired setting.
Turn the burner valve knob completely counterclockwise and preheat for 15 minutes.
For gas operation, was the safety valve knob pressed down long enough?
Insure that valve knob and regulator knob are in the “ OFF ” position.
To ignite burners turn burner valve knob counter clockwise to " ON " position.
Turn the gas valve knob to the “ OFF ” position and wait 5 minutes.
Close the release valve knob nº 17 by turning it clockwise.
The arrows on the relief valve knob shows the rotation directions for PRIME ( k ) and SPRAY p.
Push the gas control valve knob and turn to OFF see figure below, view A.
Slowly turn steam valve knob ( 7 ) counter clockwise to release steam.
Turn fluid adj . valve knob counter-clockwise to increase fluid output.
Turn the relief valve knob to the SPRAY ( p ) position.
Turn the relief valve knob to the PRIME ( k ) position.
Move the fuel valve knob to the " Open " position.
Turn the valve knob to " ON " position.
Turn burner valve knob to " HI " position.
You'll also be interested in:
Examples of using Knob
Show more
Press the volume knob during a call
Each knob is marked with an alchemical symbol
Turn the thermostat knob to a lower number
Examples of using Valve
Show more
Lift the valve assembly up and out
Grasp black lever on one drain valve
Check valve assembly caps to ensure tightness
