Examples of 'voltage' in a sentence
Meaning of "voltage"
In physics and electrical engineering, voltage is a measure of the electric potential difference between two points in a circuit. It is expressed in volts and determines the intensity of current flow
Show more definitions
- The difference in electrostatic potential between two points in space, especially between live and neutral conductors or the earth.
How to use "voltage" in a sentence
Basic
Advanced
voltage
Voltage drop due to use of extension cable.
Information on the voltage is on the rating plate.
Voltage measure switch for phase voltage.
Low battery voltage and excessive load.
Voltage measure switch for line voltage.
An incorrect voltage can destroy the device.
Voltage and frequency see data plate.
No external power supply voltage is therefore required.
Proper voltage is listed on the cleaner plate.
This criterion is verified by the voltage sensor.
Low voltage can also be suspected when.
Check if the supply voltage is supplied properly.
The voltage limitations are generally the servos.
Do not use high voltage power sources.
The voltage of the battery being tested is unstable.
See also
Keypads are low voltage for patient safety.
No voltage is coming from the wall plug.
Special current or voltage signals can be ordered.
The voltage input is calibrated in a similar way.
Check that the voltage on the rating.
Low voltage can cause a multitude of problems.
The required input voltage and frequency are.
Mains voltage is continually present on the outputs.
Measure the real value of this voltage.
Wrong voltage will damage your device.
Checkif the electricalwall outlet is of proper voltage.
Over voltage can damage the unit.
The unit uses dangerous mains voltage.
Utility voltage is present at generator control panel.
Maximum open circuit string voltage at lowest.
The forward voltage drop in mV will be displayed.
This unit uses dangerous mains voltage.
Check the voltage supplied by the generator.
Setting up discharge current and final voltage.
Check voltage at wall outlet with voltmeter.
Do not guess the rated voltage of battery.
Check for voltage at the solenoid valve.
Risk of explosion from incorrect voltage selection.
Wrong voltage can destroy the appliance.
Blinks red when an abnormal voltage is present.
Check for voltage in the mains system.
This may expose dangerous voltage to touch.
Heat or voltage is regulated by a switch on the welder.
Important note regarding charge voltage settings.
Remove low voltage wire from connector.
Observe correct polarity of incoming line voltage.
Whether there is voltage at the socket outlet.
The voltage change connector is highlighted by a square.
Reverse polarity protection of rated load voltage.
Low voltage control for greater safety.
