Examples of 'weld head' in a sentence
Meaning of "weld head"
This phrase refers to the part of a welding machine that holds and controls the welding torch. It is the component responsible for generating the heat and directing the welding process
How to use "weld head" in a sentence
Basic
Advanced
weld head
Do not remove the weld head connection.
Weld head connector is not fully engaged.
Reattach the weld head to fixture block.
Damaged electrical connections in the weld head.
Engage the weld head locking lever.
Brush spring is installed incorrectly in micro weld head.
Dirty or worn weld head body halves.
A weld head is not attached to the power supply.
Refer to the weld head user manual.
Loose drive clip in the micro weld head.
The weld head is incorrectly assembled.
Contaminants in the weld head and gas lines.
Weld head is not properly attached to the fixture block.
Damage to weld head body halves.
The weld is stopped immediately to prevent weld head damage.
See also
Connect the weld head to the fixture block.
Adjust the rotor speed or change the weld head.
Replace weld head connector cable.
Realign the rotor with the weld head opening.
Disassemble weld head and reconnect the line.
Strap is fed from a source or dispenser to the strapping or weld head.
Disassemble the weld head and clean thoroughly.
A weld head seals the strapping material onto itself.
Reduce the extension cord or weld head cable length.
Remove the weld head from the fixture block.
This connection provides the control signals to drive the weld head.
Disassemble the weld head and clean or replace components.
This computerised control unit will also control displacement of the weld head and nozzle.
The weld head is not in the true home position.
Do not connect or disconnect the weld head while the calibration is in process.
Weld head not seated properly into the fixture block.
Attach the correct weld head for the loaded weld procedure.
Weld Head indicates the weld head is connected.
Available as integrated weld heads as well as weld head modules for integration.
OD shield gas line disconnected inside weld head.
The weld head model determines the number of home positions.
Laser light is typically transmitted to the weld head through a fiber optic cable.
A stationary weld head using a part rotating mechanism also could be used.
Shield Gas indicates the gas flow to the weld head.
The opposing weld head torches are utilized to apply a weld overlay to a component.
See the motor and power block assembly drawing in the weld head user 's manual.
Disassemble the weld head and check the home sensor for dirt.
Reassemble using the instructions found in the Maintenance section of the weld head user 's manual.
Attach the weld head adapter cable to the end of the threaded multipin connector.
For best results, use constant weld head purge between welding cycles.
The weld head can not provide the speed programmed in the active weld procedure.
Shield gas will flow to the weld head until you press the button again.
Weld head was dropped Check for damage and replace parts as necessary.
Remove obstruction from weld head and press Next Home on the Main screen.
Weld head connector has broken or damaged pins / wires.
