Examples of 'welding time' in a sentence
Meaning of "welding time"
Welding time: Welding time refers to the duration or length of time required to complete a welding process. It is a crucial factor in determining the quality, strength, and efficiency of the weld joint
How to use "welding time" in a sentence
Basic
Advanced
welding time
Allows adjustment of the welding time in direct current.
The cutting of the strap is infl uenced by the welding time.
Allows regulation of the welding time in alternating cur.
The value on this time meter increases with the real welding time.
Allows setting of welding time with negative current in each cycle.
Turning this knob adjusts the spot welding time.
Spot welding time.
Consequently highly accurate welding techniques and considerable welding time is required.
The set spot welding time the arc shuts off automatically.
This can be done relatively simply though the welding time is then quite long.
The reduction in welding time results in a higher production rate and a considerable reduction in cost.
Adjustable welding time.
The welding timer performs a welding control such as a welding time and a welding current.
This would increase the welding time and the bag is safely sealed.
Use of the function " selectable welding time.
See also
Weld Time is the actual welding time in seconds at the average current.
The seal was done on a thermal sealer with a pressure of 2MPa for a 3 second welding time.
Moreover, this welding time must be adhered to strictly in practice on site.
Use the black and blue buttons to adjust your welding time to suit your needs.
When exceeding the set welding time or in case of overheating, the thermostat of the.
With manual input enabled, no welding time was set.
The welding time typically is at least two hours and at most 10 hours.
At manual welding parameter input, no welding time was entered.
Welding time for each stud is normally no more than about 20 seconds.
If the tool cuts badly, extend the welding time by one interval.
The torch trigger, depending from the selected torch mode can interrupt the spot welding time.
Referring to Fig . 8, a welding timer performs a welding control such as a welding current and a welding time.
Duty cycle is expressed as a percentage of 10 minutes and represents the maximum welding time allowed.
This machine adopts synchronous control technique . The center-control and welding time are composed of PLC.
The tolerance editor 1221 includes a weldometer which approximates material usage, electrical usage, and welding time.
Poorly welded seal ( excess material is forced out sideways ), welding time too long.
Allows you to enable the " spot welding " process and establish the welding time.
Poorly welded seal ( not welded over the complete surface ), welding time too short.
Also in this case, the factor is larger, the longer the welding time.
When the Output Voltage is below 32V with the Machine at idle no welding time.
You'll also be interested in:
Examples of using Time
Show more
Spent a lot of time with the ladies
Time and tide wait for no man
A woman needs time to think things over
Examples of using Welding
Show more
The welding process in case of metal containers
Effective removal of welding fumes and dust
Welding sparks can cause fire or explosion
