Examples of 'wet film' in a sentence
Meaning of "wet film"
Refers to a film or photographic material that has not yet been developed and is still damp or moist. It implies that the film has been exposed to light but has not undergone the proper processing
How to use "wet film" in a sentence
Basic
Advanced
wet film
Another wet film was placed on the top.
The blood is examined using the wet film method.
The resulting wet film was allowed to dry.
Wet film thickness is determined using a wet film thickness gauge.
The result is a wet film coated onto the substrate.
Weight of the wet film.
The wet film strength was decreased.
The abrasive particles are strewn into the wet film of adhesive.
The wet film is then dried in an drying oven.
Paints that can be applied at comparatively high wet film thicknesses.
The wet film should be capable of drying to a dry state.
Such polyglycol based lubricants can be used as dry or wet film lubricants.
Wet film thickness.
Solution is cast as a wet film onto a moving siliconized polyester web.
The point where it makes contact provides the wet film thickness.
See also
The wet film thickness lies between these two readings.
The foamy mixture was forced through a ribbon die to form a wet film.
A process for drying a wet film with control of loss on drying.
The wet film was deposited on the polypropylene film using a film spreader.
This photoimageable composition was applied as a wet film vía screen printing on a printed circuit board.
The wet film was covered and allowed to dry under ambient conditions.
The compound dip is often followed by another coagulant dip to set the wet film.
The área of the wet film is measured at the designated time intervals.
Kodak The photoimageable composition was applied as a wet film vía a curtain coating process.
Mm thick wet film is spread onto a flat steel panel using a film spreader.
The PTFE paste is subsequently passed through a film extrusion dye to form a wet film extrudate.
Wet film thicknesses were measured with a micrometer before removal from the support.
The Dry Time Meter has a needle that is pulled across the wet film.
Preferably such thin wet film is free of imperfections such as bubbles and dry spots.
The resulting formulations were then coated as a 6 mil wet film onto a glass plate.
Wet film solids are the solids of a liquid spray coating immediately after its application.
Thereafter, the wet film is formed and dried.
A wet film of 2 mm thickness is applied on polyethylene foil.
The finished viscosity and wet film strength were slightly decreased from 1a.
The wet film thus obtained is then dried and giving rise to a dry coating film.
The solution viscosity was slightly increased and the wet film strength was improved from 1a.
The wet film strength was improved from 1a.
A wheel-shaped thickness gauge made of stainless steel to check thickness of fresh and wet film.
The wet film strength was decrease from 1a.
Thin coats dry more quickly, giving dust less time to fall into the wet film.
Thereafter, the wet film is subjected to a drying step.
Is coated using an Erichsen Film Applicator device with a 60 micron wet film spiral applicator.
The wet film strength was slight higher than that of 1a.
Iv Drying Thereafter, the wet film is subjected to a drying step.
A wet film wheel ( eccentric roller ) uses three disks.
This coating rod gives a wet film thickness of approximately 2.5mil.
The paint is applied with an automatic spraying apparatus at a wet film thickness of ∼ 20 µm.
In one embodiment, the wet film thickness is adjusted to give proper pickup.
The coating composition is often applied such that the wet film thickness is 1 to 10 mils.
To begin, the wet film thicknesses for the various layers must be determined.
