Examples of 'work-piece' in a sentence
Meaning of "work-piece"
Work-piece (noun) - A piece or part of a work or project being worked on or produced
How to use "work-piece" in a sentence
Basic
Advanced
work-piece
Secure the work-piece to a stable platform.
Place the device on the desired work-piece and.
Work-piece before the switch is turned on.
It is possible to mount the work-piece securely during drilling.
Never use another person to support the work-piece.
Do not rip a work-piece that is twisted or warped or.
Use clamps or a vice to firmly hold the work-piece.
Heat treatment of a work-piece for obtaining an intermediate body.
Now the arc is transferred to the work-piece to be cut.
Feed the work-piece in the correct direction and speed.
Use clamps or a vise to hold work-piece whenever possible.
Place work-piece flat on the miter table with one.
Particle moving from the work-piece to the cathode.
Do not operate the saw without clamping the work-piece.
Losing control of the work-piece can cause personal injury.
Adjust the cutting depth to the thickness of the work-piece.
Never saw a large work-piece that can not be controlled.
Always use clamps or similar devices to secure the work-piece at.
Always ensure the work-piece is firmly clamped to prevent movement.
If a green body is produced without any binders it is considered as a work-piece.
Connect work clamp to work-piece as close to the weld as possible.
Continue this motion until the saw blade is perpendicular to the work-piece.
Always ensure the work-piece is firmly held or clamped to prevent movement.
The work clamp must be attached to the work-piece while cutting.
Inspect the work-piece for knots or nails before beginning a cut.
Insulate work clamp when not connected to work-piece to prevent contact.
This etches the work-piece surface and removes any scale.
The actual engraving is traditionally done by a combination of pressure and manipulating the work-piece.
Here, a cylindrically curved work-piece surface área is mentioned in an exemplary manner.
While cutting, hold the power tool as upright as possible to the work-piece surface.
Secure the work-piece properly with vice before starting your cut.
In the process of stamping or cutting out, the dies completely enclose the work-piece.
Align cutting line on the work-piece with the edge on the saw blade.
This information is then analysed in order to direct a robotic arm to remove the work-piece.
Clamp a board or strip tightly to the work-piece as an auxiliary guide using screw clamps.
In particular, the present invention relates to a screw for penetrating and securing a work-piece.
The production of each part or work-piece will require a different combination of manufacturing nodes.
Move the angle grinder across and back and forth over the work-piece.
Just be sure to direct the work-piece with your hands to avoid cutting defects.
Less than a full tooth of the blade teeth should be visible below the work-piece.
These can be optimised for the work-piece geometry and the materials to be welded.
The guard can not protect you from the blade below the work-piece.
Light reflected from the work-piece is measured and compared with a target value.
During the process, it generates an electric arc between the work-piece and the electrode.
Device used to feed the work-piece through the saw during narrow ripping cuts.
Lubrication provides an essential barrier between the roll dies and the work-piece surface.
Use a holding device to prevent the work-piece from being torn from the operator 's hand.
Different work-piece materials typically require different media for optimal productivity and performance.
By dragging the torch lightly on the work-piece you can keep the cut regular.
Feed the work-piece through the saw keeping it indexed against the rip fence.
