Examples of 'absorbance' in a sentence
Meaning of "absorbance"
The noun "absorbance" is a scientific term used to describe the amount of light absorbed by a substance
Show more definitions
- A logarithmic measure of the amount of light that is absorbed when passing through a substance; the capacity of a substance to absorb light of a given wavelength; optical density.
How to use "absorbance" in a sentence
Basic
Advanced
absorbance
Absorbance ratio of colour bound by phosphoryl cellulose.
You measure absorbance just like that.
Absorbance of the measuring solution at the maximum.
These may involve absorbance or fluorescence measurements.
Absorbance spectra were performed on all copper complexes.
It has a saturable absorbance at the emission wavelength.
Absorbance is calculated using the same equipment.
At this point a baseline absorbance reading is collected.
But absorbance is how good you are absorbing.
A linear increase in absorbance with time is observed.
The absorbance is not likely to be very high.
Linear relationship between absorbance and concentration.
The absorbance is controlled by the control current.
You could figure out its absorbance.
A decrease in absorbance indicates an increase in scavenging activity.
See also
Calculate the transmittance and the absorbance.
Mean absorbance for replicate wells are depicted.
It is also possible to achieve detection by absorbance spectroscopy.
Then the absorbance is measured as described below.
Adjust the readout electronically to zero absorbance.
A large change in absorbance indicates a positive result.
Set the read out to zero absorbance.
The absorbance values are in units of optical density.
A spectrophotometer can measure the absorbance of a solution.
Reading of the absorbance was performed as described before.
Internal digital processing converts transmission to absorbance.
The absorbance then decreased gradually to baseline.
The major peaks were detected by optical absorbance.
The absorbance correlates with cell number.
Preferred chromophores have strong absorbance characteristics.
The measured absorbance is below the calibration range.
Has an effective shock absorbance system.
Absorbance is in proportion to the concentration of proteins.
Determine the absorbance of each solution.
Absorbance per unit of optical run.
Thus the percentage absorbance or reflectance can be measured.
Absorbance measurements were averaged and converted to quantity measures.
Calculate the average absorbance of standard and samples.
The absorbance and pH are tabulated from each spectrum.
Light materials such as paper have a low absorbance.
So this absorbance is going to sit some place on this line.
Discrete design meets the best absorbance values.
Maximum absorbance per cm path length.
Heating was efficient in lowering the absorbance values.
Rapid control of absorbance of the absorber of a semiconductor laser.
An absorption spectrum is a graph of the absorbance of.
This absorbance is proportional to the quantity of living cells.
This current controls the absorbance of the absorber.
This absorbance is proportional to the number of living cells.
Can be determined by monitoring the absorbance of the solution.
