Examples of 'adsorption isotherm' in a sentence
Meaning of "adsorption isotherm"
adsorption isotherm - A graph or equation depicting the relationship between the surface coverage of a substance on a solid phase and the concentration of the substance in the surrounding phase at constant temperature
How to use "adsorption isotherm" in a sentence
Basic
Advanced
adsorption isotherm
The resulting curve of these measurements is the adsorption isotherm.
Adsorption isotherm and breakthrough curve were determined for the biochar.
The resulting curve from these measurements is the adsorption isotherm.
The adsorption isotherm data were fitted with different sorption models commonly applied to food products.
The measurement was carried out by a nitrogen gas adsorption isotherm method.
Adsorption isotherm is successfully described by Langmuir model.
These values can be obtained from the nitrogen adsorption isotherm.
The adsorption isotherm was well described by the Langmuir isotherm model.
The adsorption measured is therefore that corresponding to the plateau of the adsorption isotherm.
The adsorption can be described by the Langmuir adsorption isotherm if lateral interactions are neglected.
The pore volume distribution of the dialkoxymagnesium is determined by a nitrogen gas adsorption isotherm method.
This equation is known as Freundlich adsorption isotherm or Freundlich adsorption equation.
The pore volume distribution herein is measured by a nitrogen gas adsorption isotherm method.
The adsorption isotherm is shown in figure I.
The adsorption equilibrium constant is derived from an adsorption isotherm obtained from the measured values.
See also
Gas Adsorption uses physical adsorption and capillary condensation to measure a gas adsorption isotherm.
This is the Gibbs adsorption isotherm.
Langmuir adsorption isotherm is based on following assumptions,.
The adsorption data were fitted well with the Langmuir adsorption isotherm.
The adsorption isotherm is determined up to the equilibrium pressure of 1 torr.
N slope of Freundlich adsorption isotherm.
The type of adsorption isotherm observed was the langmuir, monolayer adsorption.
Reversible adsorption - adsorption in which the desorption isotherm approximates the adsorption isotherm.
The product under consideration adsorption isotherm is obtained by drawing the curve,.
An adsorption isotherm study was performed, monitored by analysis of UV-Vis spectra of each dyebath.
The pore volume of the component ( a ) is determined by a nitrogen gas adsorption isotherm method.
Figure 1 shows the adsorption isotherm of PSSNa on the iron oxide crystals.
Herein, the BET surface is calculated from the adsorption isotherm.
Furthermore, the adsorption isotherm for activated carbon acting as the adsorbent was determined.
In all cases, the adsorption data were well described by a Langmuir adsorption isotherm.
The Henry 's law constant for an adsorption isotherm is defined as the initial isotherm slope.
These results were compared with those obtained using the Frumkin / Temkin adsorption isotherm.
Fig . 14 shows an adsorption isotherm curve of monohydrochloride dihydrate.
This can be easily read from the adsorption isotherm of N2.
Key words, adsorption isotherm of HAP, aluminium hydroxide.
Finally, the term “ surface adsorption ” means the surface area measured on the adsorption isotherm branch.
Figure 2 depicts the n-hexane adsorption isotherm measured at room temperature.
Adsorption isotherm results, measured by UV-Vis absorbance . * omf = on mass of fibre.
For this measurement the nitrogen adsorption isotherm is extended up to 0.55 relative pressure.
The new adsorption isotherm is shown in Figure 15c.
The BET surface ( Sbet ) was calculated after conversion of the N2 adsorption isotherm into a BET plot.
The nitrogen adsorption isotherm ( FIG . 2 ) shows the presence of a characteristic working of a mesoporosity.
Specifically, the pore volume is determined from a nitrogen adsorption isotherm obtained at -196 °C.
Fig . 13 shows an adsorption isotherm curve of monophosphate.
The N2 adsorption isotherm measurement indicated that the material had a Langmuir surface área of 625 m2/g.
Fig . 2 ( a ) shows the N2 adsorption isotherm of the modified layered material.
Then a CO adsorption isotherm was measured again at 30°C.
The nitrogen adsorption isotherm of COF-5 is measured under the same conditions as COF-1.
The nitrogen adsorption isotherm curves for HY30, HYA and HYB are shown in FIG . 1.
You'll also be interested in:
Examples of using Isotherm
Show more
Each isotherm consists of four measurement points
Sets the color of the isotherm interval
Isotherm was able to describe this adsorption
Examples of using Adsorption
Show more
Adsorption to solid soil phase is not expected
Graphical representations of adsorption isotherms are provided
Adsorption on activated carbon and molecular sieves
