Examples of 'amplifier or receiver' in a sentence
Meaning of "amplifier or receiver"
amplifier or receiver - Equipment used in audio systems to increase the volume and clarity of sound output
How to use "amplifier or receiver" in a sentence
Basic
Advanced
amplifier or receiver
Speakers output terminals of the amplifier or receiver.
Connecting an amplifier or receiver in another room.
This in mind when purchasing an amplifier or receiver.
Do not connect your amplifier or receiver directly to the speakers.
Connect it to the other outputs on the amplifier or receiver.
For connection to an amplifier or receiver with coaxial input.
Disconnect both speaker cables from the amplifier or receiver.
For connection to an amplifier or receiver with optical input.
Repeat this step for connecting to your amplifier or receiver.
Always turn off your amplifier or receiver before making any connections.
Disconnect the same cord from the amplifier or receiver.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables.
Do not place the unit on a amplifier or receiver.
Operate the amplifier or receiver and adjust the volume of the other speakers.
Check the settings at the amplifier or receiver.
See also
Amplifier or Receiver Remove the short bars before connecting.
This connection is for an amplifier or receiver equipped with a.
This could create a short circuit that can damage an amplifier or receiver.
For connection to stereo amplifier or receiver with analogue input.
Follow installation directions included with your amplifier or receiver.
It must be connected only to an amplifier or receiver designed to drive 4-ohm loads.
This could create short circuits and damage an amplifier or receiver.
Operate the stereo amplifier or receiver and adjust the volume of the left / right speakers.
Use the volume control of the amplifier or receiver.
Choose only if your amplifier or receiver is not compatible with a 96KHz signal.
And that the connections to the amplifier or receiver and.
It receives signals from a remote control transmitter provided with a YAMAHA amplifier or receiver.
Connecting the Speaker Always turn off your amplifier or receiver before making any connections.
Remote control sensor Receives signals from a remote control provided with a YAMAHA amplifier or receiver.
Connecting Your Speakers Always turn off your amplifier or receiver before making any connections.
Adjust the volume using the volume control on the amplifier or receiver.
This connection is for a stereo amplifier or receiver equipped with a SUBWOOFER PRE-OUT terminal.
This could create short circuits that can damage an amplifier or receiver.
Remote control via amplifier or receiver RC-BUS.
Connecting methods and terminal names on your component such as an amplifier or receiver.
Dynamic fluctuations occur with nearly every power amplifier or receiver on the market today.
Carefully and gradually increase the subwoofer volume level on the amplifier or receiver.
Connect the speakers to the amplifier or receiver page 8.
Socket or to an AC convenience outlet at the rear of your amplifier or receiver.
If they are okay, check your amplifier or receiver.
If the system now works, the problem is in your amplifier or receiver.
Check settings in bass-management menu of the connected amplifier or receiver.
Use 16 gauge or heavier speaker wire for connecting to your amplifier or receiver.
Stereo Output, Analogue stereo output . For connection to stereo amplifier or receiver with analogue input.
Do not place the deck directly on top of a ( power ) amplifier or receiver.
Digital coaxial out Connect to digital coaxial ( S / PDIF ) input on an amplifier or receiver.
Digital optical out Connect to digital optical ( S / PDIF ) input on an amplifier or receiver.
You'll also be interested in:
Examples of using Amplifier
Show more
Make sure that the amplifier is switched on
Amplifier is picking up alternator noise or radiated noise
Never operate the amplifier without cover
Examples of using Receiver
Show more
Occupiers refuse receiver entry into shipyard
Receiver unit is outside the maximum range
Make sure that the receiver is turned on
