Examples of 'blade height' in a sentence
Meaning of "blade height"
Blade height refers to the distance between the blade and the cutting surface. This term is commonly used in the context of tools or machines with cutting blades, such as lawnmowers or saws, where adjusting the blade height can affect the cutting efficiency or the desired outcome
How to use "blade height" in a sentence
Basic
Advanced
blade height
Blade height adjustment is usually not necessary.
See adjusting the blade height.
Set the blade height and angle.
Raise the blade fully by rotating the blade height.
Adjust the blade height so that the blade.
Check using a straight edge in all bevel and blade height positions.
The squeegee blade height is easily adjustable at the caster wheels.
The desired blade height.
Raise the blade arbor to its maximum by rotating the blade height.
The mower has seven blade height adjustment positions.
The distance between the root and the tip is known as the blade height.
The mulcher has eight blade height adjustment positions.
Raise the saw blade arbor to its maximum height by turning the blade height adjustment.
Customize configuration by adjusting blade height or by adding additional blade assemblies.
Turn blade height adjustment wheel ( M ) to raise mechanism as high as it will go.
See also
The mounting plate also has guides in which a blade height adjustment slide can run.
Never adjust blade height with the cutter head in the locked position.
The mixture was blended while slowly raising the mixer blade height with the rising foam.
Measure the blade height again to ensure it now matches the height on the dial.
This is accomplished by setting a blade height control flag to “ 1 ”.
Rotate the blade height adjustment wheel to lift the motor to its highest position.
Adjusting the blade height & level.
A blade height regulation mechanism 22 manually operable by an operator is connected to the blade 16.
A maximum of only 1/3 of the grass blade height should be cut in one pass.
In practice the tip clearances are typically between 1 and 2 % of the blade height.
When adjusting blade height only, both left and right screws must be equally.
One full turn of the handwheel will change blade height approximately 1/4.
The saw blade height is recommended about 3.2 mm above the top of the workpiece.
Repeat steps 5 and 6 until the correct blade height and level is achieved 8.
Adjust the blade height so that the blade is about 1/8.
Never cut thin or young lawn too short leave 3 - 4 cm blade height standing.
The blade height 18 varies so it remains within the rotor 's cylindrical generatrix 19.
Remove the lock knob ( BB ) and blade height adjustment wheel M.
Never cut thin or young lawn too short 3 - 4 cm blade height.
Saw blade height adjustment Fig . 4.
Take hold of the elevating handle ( 11 ) and adjust the blade height.
You'll also be interested in:
Examples of using Height
Show more
Height and weight are about the same
The armrest can be height adjusted as follows
Height and depth adjustable steering wheel
Examples of using Blade
Show more
Propeller blade must have cut it in half
This guy knew how to use a blade
Rotate the blade so it falls into place on
