Examples of 'bolt head' in a sentence
Meaning of "bolt head"
This phrase is used to describe a person who is not very intelligent or lacks common sense. It can also be used to refer to someone who is stubborn or inflexible in their thinking
How to use "bolt head" in a sentence
Basic
Advanced
bolt head
It just breaks every bolt head simultaneously.
Bolt head goes on inside of tractor frame.
The screw bolt includes a bolt head.
Bolt head always on the eccentric washer side.
Install protective bolt head cap on each enclosure stud.
It was caused by a bracket or a bolt head or.
The bolt head is a replaceable part.
Having a bolt with a removable bolt head presents a significant advantage.
The bolt head is inset and covered with a plug.
Bend the lock washers against the bolt head after tightening.
Bolt head always on the same side of the eccentric washer.
Insert the fi rst bolt head into the hole in the guard.
Countersink planks for recessing of the washer and the lag bolt head.
Each bolt head type includes a different means of cartridge ejection.
Tighten screw of clamping device until bolt head and end of cover are aligned.
See also
The bolt head should contact the bottom of the lower leg.
Furthermore they have an assembly direction defined by the bolt head or screw head.
The bolt head has a lower surface on which is an undulating surface pattern.
Make sure there is no interference with the central bolt head when heel is compressed.
Hold bolt head with a separate wrench and tighten all mounting bolts and nuts with a wrench.
Mounting bolts should be installed with the bolt head at inside surface of the transom.
The cause of the accident appears to have been his sleeve catching on a bolt head.
Position flat washers between the bolt head and the fluid cooler basin flange.
The stepped bore defines a shoulder which engages the bottom of the bolt head.
The second receiving portion has the bolt head of the screw bolt received therein.
The bolt is shown under the barrel with cartridge attached to the protruding bolt head.
Cover every bolt head with a bolt cap CC.
I also countersunk the holes so that the hex bolt head would sit flush.
Click the Bolt head of the Counter Weight as illustrated.
On wood sills use the large washer between the bolt head and the sill.
You can, but the bolt head will have to be changed.
A positive lock can occur at the intermediate plate and the bolt head during braking.
Also preferably, the bolt head has an unthreaded central aperture.
Put the lock washers between the outside of the handle and under the bolt head.
If the bolt head is spring loaded during locking, permanent locking is safeguarded.
So you were all on your boat moored off Bolt Head.
For stainless steel clamps, tighten bolt head until clamp is securely fastened.
Alternatively, such a washer may be integrated into the bolt head design.
It featured a rubber obturator on its bolt head to provide a more efficient gas-seal.
If the bolt head is square when viewed head-on, the wedge portion will be pyramidal.
The fastener of claim 1, wherein said bolt head defines a tapered abutment surface.
The bolt head 16 could be constructed with any other equivalent tool interfaz surface configuration.
They could, for example, also be arranged at a bolt head of the adjustment bolts.
Also, the bolt head does not have to comprise any means for receiving a bolt cover.
A lower end of the motion sensor rod 8 is pressed against a bolt head of the bolt 5.
As the firing pin retracts, the bolt head turns anti-clockwise unlocking the breech.
A flush-fronted exterior appearance is maintained by countersinking the bolt head in the outer pane.
The fixing bolt head diameter should be more than 12mm.
The orthopaedic knee component of claim 8, wherein said bolt head is recessed within said opening.
Bolt head 46 has a laterally positioned side exterior surface 52 also shaped for good tool purchase.
