Examples of 'burner head' in a sentence
Meaning of "burner head"
A burner head is the part of a gas stove or burner that produces the flame. It is typically a metal structure with small openings through which the gas flows, allowing for combustion and the generation of heat
How to use "burner head" in a sentence
Basic
Advanced
burner head
Remove burner head from burner assembly.
Reinstall spark plug into burner head.
Wok burner head enameled cast iron.
Make sure plug is in place on burner head.
To clean the burner head ignition ports.
Cap is permanently attached to the burner head.
Extra large burner head and cap.
Burner head and removable cap select models.
Check installation of burner head and cap.
Burner head and cap assembly.
Position the burner cap on the burner head.
Small burner head and cap.
Reinstall spark plug in burner head.
Replace the burner head on top of the burner.
Slide the pot support into burner head.
See also
Medium burner head and cap.
Put the burner cap on the burner head.
This burner head is received in a housing.
The burners advantageously comprise a circular burner head.
Check that the burner head is in the proper position.
Attach fuel and air line hoses to burner head.
Place the burner head onto the burner base.
Place the burner cap on top of the burner head.
Each burner head has a small ignition port located as illustrated.
Hold a lighted match to the desired surface burner head.
The direction of burner head and burner ring does not matter.
Pay attention to good flame contact at the burner head.
Remove grate section and burner head to sink for washing.
The gases are usually injected through lances in a burner head.
The ports or slots around the burner head must be routinely cleaned.
Food has been spilled on the mesh under the burner head.
Make sure the hole in the burner head is positioned over the electrode.
The outer cap is permanently attached to the burner head assembly.
Before replacement on the burner head ensure that the holes are not clogged.
Do not attempt to remove oval burner cap from burner head.
Lift off a burner head and fit the pressure gauge to the injector.
The grates fit over the raised area on the burner head.
Make sure the slot in the burner head is positioned over the electrode.
The bridge burner cap is permanently attached to the burner head assembly.
The alignment of the burner head and the burner ring is not important.
The cap rests directly upon the skirt of the burner head.
Make sure the notch in the burner head is positioned toward the electrode.
The opening of the plunger allows gas to flow to the burner head.
The burner head may again serve to provide the opposing electrode means.
Slide the open part of the pot support onto the burner head.
Pull out the pilot tube and burner head assembly for cleaning and inspection.
Make sure that the burner cap is properly seated on the burner head.
Rotate the burner head around the burner base until it is level and securely seated.
The electrode of the spark igniter is exposed when the burner head is removed.
Position the burner head such that the heat sensor is positioned in the appropriate slot.
