Examples of 'burner should' in a sentence
Meaning of "burner should"
The phrase 'burner should' typically refers to a situation where a burner, which is a heating or cooking device, must be operated or used in a specific way to achieve a desired outcome
How to use "burner should" in a sentence
Basic
Advanced
burner should
The burner should ignite at the high position.
A small yellow flame from burner should be blue.
The burner should be no more than half full.
Turn the valve to on and the burner should light.
The burner should light when gas is available to burner.
Once the igniter is hot the oven broil burner should light.
The flame from the burner should be visually checked.
The burner should be serviced at least once a year by a qualified specialist.
Any kind of efficient fat burner should be multipurpose in its techniques.
The burner should be serviced at least once a year by a trained specialist.
When operating the flame from the burner should be visually checked.
The grill burner should be cleaned after each use.
To eliminate reaching over surface burners, cabinet storage above burner should be avoided.
The burner should never be operated if the cap is not in place.
Remove the restriction and the burner should come back on in a few minutes.
See also
The burner should be equal distant between the crossover channels.
Remove the obstruction and the burner should restart after a few minutes.
Burner should be cleaned with a wire brush to remove debris and corrosion build up.
The side facing the burner should be facing outwards in the bottle.
Minimum distance between the switch and the edge of the burner should be 4 inches.
The surface burner should ignite when gas is available to the burner.
Having completed the checks indicated in the previous heading, the burner should fire.
The bridge burner should be used only with the griddle in place.
The supply and pressure of the atomizing air on an oil-fired burner should be checked.
The flame size on a gas burner should match the cookware you are using.
Burner should ignite within 4 seconds.
After adjusting the screw the burner should produce a stable, steady blue flame of minimum size.
Burner should then cycle on and off to maintain an average temperature of approximately 300 F.
Once the air has been purged from the supply lines, burner should ignite within 4 seconds.
The main burner should remain lit when the red button is released.
Within 60 seconds the oven burner should ignite.
The surface burner should light when gas is available to the top burner.
Within 60 seconds the broil burner should ignite.
The burner should be visually inspected to ensure it is free from any foreign matter.
Gap between electrode and burner should be between 5 and 6 mm.
The main burner should be blown dry or heated to remove water from main burner.
Push and turn the control knob to “ + ” position and burner should light immediately.
The burner should glow red with a minimum amount of flame lap after initial firing.
The space between the electrode tip and burner should be approximately 3/16 ”.
The surface burner should light once the flow of gas reached the surface burner.
The gap between the electrode tip and burner should be approximately 3/16 of an inch.
Each burner should light in 4 seconds or less.
During the optimization ( A. 7 ) the burner should not come above this position.
The burner should light within approximately 5 seconds.
The oven bake burner should light within 8 seconds.
The burner should light within the first 4 seconds.
The motion of the burner should be straight-forward, without transverse oscillations.
The burner should ignite before the high+ position.
The gas burner should be cleaned as needed, but at least once a year.
Main burner should now light IMMEDIATELY and flame should not " lift " off burner.
You'll also be interested in:
Examples of using Burner
Show more
The burner lids are not correctly positioned
Test each rangetop burner in this fashion
Each burner has its own igniter
