Examples of 'cable shield' in a sentence
Meaning of "cable shield"
cable shield: A protective covering or layer surrounding a cable, used to insulate, protect, and shield the cable from external factors such as electromagnetic interference, physical damage, or environmental elements
How to use "cable shield" in a sentence
Basic
Advanced
cable shield
Connect cable shield at both ends.
Create a break in the signal cable shield conductor.
Poor cable shield terminations is the top issue.
The conduit must have bonding at both ends as with cable shield.
Ground the motor cable shield at the motor end.
The cable shield is also grounded t a reference ground potential.
The minimum requirement of the motor cable shield of the drive is shown below.
The cable shield should be connected to the green ground screw in the sensor housing.
Loosen the two screws on the cable shield and detach the bottom part.
Severe leakage usually results from improperly installed connectors or faults in the cable shield.
Attach the bottom part of the cable shield to the unit casing with the screw.
The cable shield must not be connected to the system 's earth connection but left free ;.
Battery cable Shield.
Pin 1 should be left unconnected and Pin 3 should be connected to the cable shield.
Connect AC power cable shield to metal backplane using conductive shield.
See also
The longitudinal tape 14 is optional in the cable shield.
Grounding of the motor cable shield at the motor end For minimum radio frequency interference.
Connect pin 1 to pin 3 and the cable shield.
Encoder cable Shield.
As the connector 10 is metallized, conductive continuity may be established between cable shield 16 and housing 20.
If present, connect cable shield to an earth ground at the power supply.
Moreover, it is not uncommon for a cable shield to be earth grounded.
In the device, the cable shield must be connected directly to the internal ground terminal.
As previously mentioned, one common additive to cable shield compositions is an antioxidant.
Connection of a cable shield occurs on terminal 46b.
Re-attach the top part of the cable shield by tightening the two screws.
At the motor end the cable shield should be earthed through a 10 nF capacitor.
Wherever possible, the power supply cable shield should be connected to the boat 's ground plate.
To ground the cable shield 360 degrees at the cabinet entry.
You'll also be interested in:
Examples of using Shield
Show more
A shield has appeared around the outpost
He will have that shield down on time
Connect shield to an earth ground at power supply
Examples of using Cable
Show more
Secure the coaxial cable to the ceiling
A cable tie is provided with the appliance
Use plenum rated cable where it is required
