Examples of 'change lever' in a sentence
Meaning of "change lever"
Refers to a lever or control mechanism that is used to adjust or switch between different options or settings. It is often found in machines or devices that require manual adjustment, such as a gear lever in a car or a volume control lever on a stereo
How to use "change lever" in a sentence
Basic
Advanced
change lever
Set the change lever to theh symbol.
This tool has an mode change lever.
Rotate the change lever to the position.
This tool employs an action mode change lever.
Set the change lever to the or symbol.
Templet guide quick change lever.
Switch the change lever without mistake.
A little difficult to slide the mode change lever.
Set the change lever to theg symbol.
Protection of the tpu change lever.
Mode change lever to the left symbol.
Always set the speed change lever fully to the.
The change lever is in a position other than neutral.
Do not rotate the change lever when the tool is.
Loosen the screws and remove the change lever.
See also
Set the change lever to middle of mark and.
May be a little difficult to slide the mode change lever.
A gear change lever was mounted directly on the gearbox.
Changing the position of holding the change lever allows.
The gear change lever was on the steering column.
Always slide the action mode change lever all the.
Set the change lever so that the pointer points to the symbol.
First slide the action mode change lever to the position of.
Set the change lever and the shift lever to the symbol.
Two speed ranges can be preselected with the speed change lever.
Do not use the speed change lever while the tool is.
Speed change lever o Adjusting ring p Graduations a Drill marking s Pointer d Limit mark f Screwdriver g Brush holder cap.
Do not use the action mode change lever while the tool is running.
This tool has a three-gear speed change lever.
Always press the change lever until it engages in the end position.
Never remove it forcibly without aligning the change lever with the symbol.
Rotate the change lever so that the pointer points to the symbol.
Always remove the crank cap only after aligning the change lever with the symbol.
Always set the speed change lever fully to the correct position.
For chipping, scaling or demolition operations, rotate the change lever to the position.
Do not rotate the change lever when the tool is running under load.
When boring brick of similar materials, slide the change lever to the right.
Always slide the action mode change lever all the way to your desired mode position.
For continuous chipping, scaling or demolition operations, rotate the change lever to the symbol.
Always make sure that the change lever is properly set to the position.
When boring metal, wood or plastic or tightening, sliding the change lever to ROTATION side.
Set the change lever to the LOCK position to lock the trigger.
Be sure to set the change lever to the LOCK.
The gear change lever is in neutral position or in neutral gear, or.
For screwing, slide the action mode change lever to the right symbol.
Set the change lever to the FREE position.
For drilling, slide the action mode change lever to the left symbol.
Set the change lever to the H symbol.
For rotation only, slide the action mode change lever to the left symbol.
Rotate the change lever counterclockwise for roto-orbit.
You'll also be interested in:
Examples of using Lever
Show more
Do not lift lever during brewing cycles
Lever can be adjusted to a different lever angle by
Open the lock lever to unlock footplate
Examples of using Change
Show more
Ming will not change his mind
Change duct size gradually to minimize turbulence
You can even change your name to
