Examples of 'chimney connector' in a sentence
Meaning of "chimney connector"
chimney connector - a component that connects a stove, fireplace, or heating appliance to a chimney for proper ventilation of smoke and exhaust gases
How to use "chimney connector" in a sentence
Basic
Advanced
chimney connector
The chimney connector must be in good condition.
Clearance can be reduced if a listed chimney connector is used.
Do not use chimney connector pipe as a chimney.
They are fixing the chimney connector.
The chimney connector must be short and straight.
An uncontrolled burn or a glowing red part or chimney connector indicates excessive draft.
Each chimney connector or stove pipe section must be.
An uncontrolled burn or a glowing red part or chimney connector can indicate excessive draft.
The chimney connector joins the stove to the chimney.
There should also be a support sized to fit and hold the metal chimney connector.
Insert a section of chimney connector into the chimney.
The chimney connector must be in good condition and kept clean.
Open inside wall at proper height for the chimney connector to entry the masonry chimney.
The chimney connector and dampers as well as the chimney should be cleaned.
INSTALL three sheet metal screws at every chimney connector joint.
See also
Disassemble the chimney connector and clean the sections.
Using a manometer with an appropriate scale range, connect the testing tube to the chimney connector.
For proper operation the chimney connector should be as short as possible.
Use this as a passthrough for a minimum 24-gage single wall steel chimney connector.
The chimney connector has been designed to withstand the intense heat of a chimney fire.
Whenever possible, avoid passing the chimney connector through a combustible wall.
The chimney connector is a single walled pipe used to connect the stove to the chimney.
The venting system consists of a chimney connector ( also known as stove pipe ) and a chimney.
Your chimney connector and chimney must have the same diameter as the appliance 's exhaust outlet.
The pad must cover any horizontal chimney connector runs and extend 2 ” beyond each side.
If the chimney connector pipe glows red or - even worse - white, the stove is over-fired.
A clearance of 10.5 ” between single wall chimney connector and combustible materials is required.
The chimney connector should be 6 ” diameter black steel, with a minimum thickness of 24 gauge.
Also check with the chimney connector manufacturer for any specifi c requirements.
Secure the chimney connector to the outer end of the sleeve with sheet metal screws.
Secure adjoining sections of chimney connector to each other using three equally spaced.
Follow double wall chimney connector manufacturer 's instructions regarding proper pipe installation.
A thermometer on the chimney connector and / or appliance top helps.
Seal the end of the chimney connector to the clay liner with refractory mortar.
INSTALL single wall chimney connector with the male end down to prevent creosote.
If the stove or chimney connector glows, you are overfiring.
For proper operation, the chimney connector should be kept as short as possible.
The small ends of the chimney connector should all point down for a drip-free installation.
You'll also be interested in:
Examples of using Connector
Show more
Only the appropriate connector must be used
Purple connector for black whip antenna
Plug the charger connector into the
Examples of using Chimney
Show more
No stove or chimney will ever burn down
Chimney minimum height above the roof
You have your chimney cleaned by a competent
