Examples of 'contact resistance' in a sentence
Meaning of "contact resistance"
contact resistance - In the field of electronics and electrical engineering, contact resistance refers to the resistance encountered at the interface between two conductive materials. It is an important factor to consider in circuit design and can affect the efficiency and performance of electrical connections. Lower contact resistance is generally desirable for ensuring proper conductivity.
How to use "contact resistance" in a sentence
Basic
Advanced
contact resistance
Three contact resistance measurements during indentation.
It is therefore desirable to reduce this contact resistance.
Method for reducing contact resistance in a transistor.
Contact resistance may vary with temperature.
This also increases the contact resistance.
The contact resistance is consequently very low.
It also avoids any inaccuracy because of contact resistance.
The contact resistance becomes very low.
R sheet roll contact resistance.
The contact resistance must therefore be as low as possible.
Tighten the nuts well for minimal contact resistance.
Contact resistance is then quite minimized.
The inverse of this property is termed thermal contact resistance.
The contact resistance can therefore be poorly controlled.
This finish improves the final contact resistance obtained.
See also
Specific contact resistance can be obtained by multiplying by contact area.
Solderability is shown by wetting balance testing and contact resistance.
The contact resistance and reduce the temperature rise.
The metal coating is required to ensure low contact resistance.
The contact resistance was evaluated based on the following criteria.
This technique is effective for reducing the contact resistance.
Typical contact resistance.
Contact resistance problems.
Simplistic graphene transfer process and its impact on contact resistance.
The contact resistance decreased with increasing tube or bundle diameter.
Numerous processes have been adopted in order to reduce this contact resistance.
The contact resistance can decrease further if contact pressure is increased.
Said end portions can be treated to reduce the contact resistance.
Minimize the contact resistance of the wire in the test circuit.
There results an electrical contact having an extremely low contact resistance.
Controlling contact resistance is essential in order to accurately measure impedance in the body.
The quality of the connection can be expressed in the contact resistance.
Resulting electrical contact resistance isfound to be much lower than experimental results.
The device measures both frictional forces and contact resistance.
Low friction force and contact resistance with fine carbon brush.
Separators of polymer electrolyte fuel cells require a low contact resistance.
The contact resistance obtained by this method is about several tens of ohms.
The sensitivity for measuring low contact resistance may be significantly improved.
The contact resistance was already almost constant after about ten hours.
Pay attention to a good contact so that no interfering contact resistance will result.
The surface contact resistance was measured using the method described above.
Unpurified silicones have a very strong adverse effect on the contact resistance.
Verification that the contact resistance is below pre specified limits is required.
This causes rust to generate and grow so as to increase the contact resistance.
The initial contact resistance was discerned independent of the profile of raised portions.
The switch position buzzer is used for checking continuity and contact resistance.
It is dependent on the contact resistance of the intermediate connections and the cable layout.
This relationship between the diameters ensures that the contact resistance is negligible.
A sufficiently high contact resistance can cause substantial heating in a high current device.
Adopt new fiber brush technology to ensure low friction and low contact resistance.
You'll also be interested in:
Examples of using Contact
Show more
I have little contact with the neighbours
Contact officer for national report if different
We can not contact the victim either
Examples of using Resistance
Show more
National resistance to the occupation was therefore legitimate
This must result in a resistance value of approx
Resistance to surface damage by fine particles optional
