Examples of 'corrosion rates' in a sentence
Meaning of "corrosion rates"
Corrosion rates are a measure of how quickly or slowly a material degrades or deteriorates due to chemical reactions with its surrounding environment. It indicates the speed at which corrosion occurs, typically expressed as a percentage or a specific rate of material loss over a given time period
How to use "corrosion rates" in a sentence
Basic
Advanced
corrosion rates
Grid corrosion rates increase with temperature.
At supercritical temperatures the corrosion rates were low.
The corrosion rates were determined by weight loss.
Instantaneous and mean corrosion rates.
Very low corrosion rates in the system.
Free chlorine may increase copper corrosion rates at low pH.
High corrosion rates are initially observed.
It also greatly accelerates the corrosion rates by atmospheric oxygen.
The corrosion rates are negligible.
Trends of corrosivity based on corrosion rates and pollution data.
Corrosion rates below one meter diminish significantly.
Weight losses were then determined and corrosion rates calculated.
Influences corrosion rates and remaining life assessment.
The additives defined have very low corrosion rates in water.
Decreases in corrosion rates varied between materials and sites.
See also
This leads to the concepts of acceptable corrosion rates and pollution levels.
Corrosion rates depend on the depth of submersion and seawater conditions.
It is expected that flow assisted corrosion rates follow this type of behavior.
The corrosion rates in marine and rural atmosphere are very low.
Operation at the lower temperature reduces reactor pressure and corrosion rates.
The corrosion rates declined sharply as a function of decreasing relative humidity.
It my be used to adjust the dispersant dosage when high corrosion rates occur.
Corrosion rates were found to vary according to the marine exposure zone.
It is shown that irradiation can increase corrosion rates within the parameters of dose.
Corrosion rates increase with increasing acid concentration and temperature.
Here it is found that the corrosion rates for carbon steel are the lowest.
The levels of nitric acid could partly explain the different corrosion rates.
Inferences about corrosion rates of engineering alloys still need to be made.
Corrosion coupons were inserted in certain process locations and measurements made of corrosion rates.
A guideline for corrosion rates and material selection is as described below.
For the technical plants now in use smaller corrosion rates are required in particular.
High corrosion rates are found for the formulation containing borate.
The corrosion maps were combined with tolerable corrosion rates to identify areas of exceedance.
In this study corrosion rates that were hundred times higher were measured.
Using the listed polymers electrochemical screening tests were performed to determine corrosion rates.
Corrosion rates due to past and present exposure to multiple pollutants were monitored and calculated.
The presence of oxygen increases corrosion rates and the types of corrosion that occurs.
Corrosion rates for all types of steel vary depending upon the environmental conditions.
This reduces the tightness of fit leading to liner stability problems and increased corrosion rates.
Electrochemical corrosion rates were measured using admiralty brass or low carbon steel working electrodes.
Therefore, these tubes are exposed to higher corrosion rates.
Corrosion rates also increased when the zinc content was reduced to near impurity levels.
The following corrosion rates were obtained,.
Nevertheless, slip steps have shown a strong impact on corrosion rates.
The corrosion rates for the recirculation line coupons and reservoir coupon were calculated.
If done incorrectly, it results in increased corrosion rates and weakened materials.
High corrosion rates are seen typically within the top one meter of the net.
In particular, when assembled welding locations are susceptible to faster corrosion rates.
The corrosion rates of this example were determined by the PAIRR technique.
From the coupon weight losses, the corrosion rates in mpy were calculated.
You'll also be interested in:
Examples of using Rates
Show more
Household borrowing rates have remained steady
Rates of disability and handicap among children
Effects of changes in rates of exchange and inflation
Examples of using Corrosion
Show more
This will prevent corrosion of electrical components
Corrosion can form under such residues
Chlorine causes corrosion on such metal surfaces
