Examples of 'creep test' in a sentence
Meaning of "creep test"
creep test: This phrase is commonly used in software engineering to describe a test that checks if a system behaves properly when running for a long period with a gradually increasing workload
How to use "creep test" in a sentence
Basic
Advanced
creep test
The creep test is performed as follows.
Procedures adopted for the drying creep test.
The result of the creep test is given in minutes.
Retesting is permitted for the high temperature creep test.
Warm creep test.
A creep test is a tension test run at a constant load and temperature.
Method of extrapolating creep test results.
Creep Tests The creep test is performed as follows.
High temperature creep test.
The creep test is performed at the following temperatures,.
Determination of the initial properties of materials and creep test conditions.
A Scatter of creep test results.
The pipe was also subjected to the full notch creep test.
On the pipes the full notch creep test was carried out.
Additionally, the results from a tensile test cannot be transferable to that of a creep test.
See also
That was a creep test.
Right, Creep test assemblage for corrosive environment studies.
Uninterrupted creep test.
The creep test was performed with a Haake RT20 Rotoviscometer using a parallel plate configuration.
Interrupted creep test.
In Table 3 is shown the amount of specimens for each group of drying creep test.
High temperature tests Creep test for steel.
Creep Test Sample dimension and test conditions Examples 1.
It is also excluded to wait several years to perform a creep test on a specimen.
The following creep test conditions where used,.
Test temperature relating to the High temperature creep test duration.
The results of the creep test are presented in the table below,.
The cohesive strength parameter Y is measured using the rheological creep test as described hereinafter.
Figure 3 is a plan view of a creep test piece cut from the welded body of Figure 2.
Pressure relief devices a Creep test.
The result of the creep test is given in N / cm.
The test equipment is simple, being the usual set-up for a tensile creep test.
Table 3 below collates the results of the creep test obtained for the various samples.
In Figure 2, can be seen the mold used for the creep test.
The results of the shear creep test are shown in Table 2.
Development and 3D design of an in-reactor material creep test device.
The results of the creep test are summarized in Table 10.
The diagram of Figure 2 ( a ) is an example of the thermal fluctuation recorded during a creep test.
The procedure for performing the Creep Test is as follows,.
For the creep test a stress of 600 Pa is applied.
Table 3, Test temperature relating to the High temperature creep test duration.
Figure 9 is a graph showing the creep test results of Figure 8 versus time.
Deformation F after creep test ( mm ).
Composition of the steels and creep test results stresses causing rupture in 10 000 hours.
The tests where performed on a compression creep test machine according to ASTM standard D 695-80.
The ZSV value is obtained from creep test at 190°C vía the method described above.
The ZSV value is obtained from creep test at 190°C via the method described above.
You'll also be interested in:
Examples of using Creep
Show more
We need to be able to creep on him at all times
That creep better not be taking pictures
Working with this creep is too dangerous
Examples of using Test
Show more
Mechanical tensile test prehoistable navigation lights
A test with tripping is compulsory on installation startup
Before the test we had art class
