Examples of 'crosshead' in a sentence
Meaning of "crosshead"
Crosshead is an adverb, used to describe a type of engine mechanism where the motion is converted from rotary to reciprocating. It is used in engineering contexts
Show more definitions
- A metal beam that connects a piston to a connecting rod in an engine.
- Large text, like a headline but typically drawn from the article, placed partway through the article to break it up visually.
- A screw with a cross-shaped indentation for gripping and turning, as opposed to a flathead.
How to use "crosshead" in a sentence
Basic
Advanced
crosshead
A three bar crosshead was added to the motion.
These engines typically use crosshead pistons.
Use a suitable crosshead screwdriver to remove this clamp.
The área presented to the crosshead is computed.
Crosshead speed of the testing machine.
This required the use of a crosshead.
Six crosshead screws keeping the casing in place.
The crankshaft is between the crosshead and cylinder.
Then the crosshead is set at zero.
The air pump was driven from each crosshead.
Start the crosshead moving downward.
They act both as a piston and cylindrical crosshead.
Then the crosshead was set at zero.
The deformation is measured by following the crosshead displacement.
You will need a crosshead screwdriver to complete this procedure.
See also
Several layers can be applied using a multiple crosshead.
Use a suitable crosshead screwdriver to open the housing carefully.
A cord was attached from the slide to the crosshead.
Crosshead speed in testing machine.
In most cases a crosshead crank gear is used for this.
Remove the blue screw with an appropriate crosshead screwdriver.
The crosshead is started in motion.
Set the plug and push it by using a crosshead screwdriver.
Run the crosshead down until the specimen ruptures.
The air pumps were driven from each crosshead.
It is recommended to use a crosshead screwdriver and a spanner both not supplied.
Guide bars for a crosshead.
This extrusion crosshead can be designed for all kind of compounds.
Slide bars for a crosshead.
A triple crosshead allows all three layers to be extruded at one time.
This mandrel fits thight in an annular body of the crosshead.
Mushroom crosshead screw.
It was attached to the load cell of the tensile tester on the crosshead.
The speed of the crosshead was adjusted to achieve target injection rate.
The melt pump was connected to a crosshead and cable die.
The crosshead drives.
This bedplate mounting bracket is fastened to the crosshead of the counterweight.
Use a crosshead screwdriver to remove the brackets that hold the lens in.
The assembly of the cabinet requires the use of a regular crosshead screwdriver.
The tensile test uses a crosshead speed of two inches per minute.
The crosshead travel is set and continues until the specimen breaks.
Close the battery compartment by screwing in the screw with a crosshead screwdriver.
The crosshead travel was set and continued until the specimen breaks.
The elongation of the test pieces is measured from the crosshead displacement.
The test is complete after the crosshead automatically returns to its initial starting position.
The tensile tester is then activated so that its crosshead moves downward.
Preferably each travelling crosshead is provided with its own hydraulic fluid reservoir or accumulator.
Two or more extruders are typically connected to a crosshead die to extrude the profile.
The force measurement is performed through a tensilecompression load cell placed on the movable crosshead.
The counterweight assembly may include a crosshead to which the counterweight sheave is journaled.
