Examples of 'curing time' in a sentence
Meaning of "curing time"
Refers to the duration required for a substance or material to undergo the process of curing, usually in relation to adhesives, coatings, or compounds. It represents the time needed for the material to reach its desired strength, hardness, or other properties
How to use "curing time" in a sentence
Basic
Advanced
curing time
In particular the curing time is considerably extended.
Heat may be applied to decrease curing time.
It has a longer curing time than others.
The curing time decreases with decreasing temperature.
A catalyst can be added if curing time is desired to be decreased.
Curing time was determined under ideal application conditions.
The latter demonstrates significant reduction of curing time.
Curing time is faster than for normal adhesives.
Follow label guidelines for paint curing time.
Curing time may be increased in winters.
This step required a curing time.
Preferably the curing time is determined as hereinbefore defined.
Other advantages are fast activation and curing time.
The curing time is typically about three hours.
Lower temperatures will extend the curing time.
See also
Curing time increases with low humidity levels.
Requires a longer curing time than some other paints.
Curing time refers to the lowest temperature in the range.
Apply the correct film thickness and curing time.
Respect the curing time given by the manufacturer of glues.
The binder adhesive preferably has a long curing time.
Curing time should be increased for darker resin shades.
Speeds construction due to reduced setting and curing time.
The curing time depends on the climate of your area.
There is a much longer curing time for the mud mixture.
The curing time can typically be from days to months.
The green leaves turn yellow during the curing time.
Respect the curing time specified by the manufacturer of these products.
It is possible to improve the curing process by reducing the curing time.
Curing time is significantly reduced compared to conventional liquid gel coats.
Other combinations of curing time and developing speed are also possible.
Allow the putty to cure heat will accelerate the curing time.
No curing time required.
The adopted factors were petroleum oily sludge percentage and curing time.
The curing time for polyisocyanurate foam is about ten seconds.
Use of other active materials may shorten pressing and curing time.
The curing time of the resin can be controlled by adding amounts of a catalyst.
Concentration of catalyst is an important factor in reducing curing temperature and curing time.
The curing time is longer at lower temperatures and shorter at higher temperatures.
Allow curing in accordance to the minimum curing time at room temperature before operation.
The curing time may vary between a few seconds to several hours.
It is possible to use below freezing point but there are questions about curing time.
The curing time can vary from forty seconds to five minutes.
The reason for these high temperatures is to reduce the average curing time.
Curing time is significantly faster with powder coating than with liquid coating.
With a long period of natural curing time that often turns into six months.
A short curing time should be sought in order to increase the manufacturing process rate.
At elevated temperatures there was a great increase in the curing time for both dithiocarbimates complexes.
The effect of curing time on the strenght and endurance of high strenght concrete.
The addition of additives considerably improve the curing time and the varnish quality.
