Examples of 'cutting forces' in a sentence
Meaning of "cutting forces"
cutting forces: In engineering, cutting forces refer to the forces acting on a tool or workpiece during a cutting process, such as machining. Understanding cutting forces is crucial for optimizing the machining process and achieving desired results
How to use "cutting forces" in a sentence
Basic
Advanced
cutting forces
Low cutting forces for small machines.
A feather key groove absorbs the cutting forces.
Reduced cutting forces thanks to new geometry.
Increase the cutting forces.
Lower cutting forces and shorter chips than other solutions.
This includes the monitoring of cutting forces and vibrations.
Increased cutting forces will shatter the work piece.
All of these blades improve the distribution of cutting forces.
The specific cutting forces are measured.
No movement of the cutting insert under impact of cutting forces.
This results in the cutting forces becoming large at entering.
The special flute profile yields a significant reduction in cutting forces.
Low cutting forces.
Significantly higher cutting forces.
Lower cutting forces reduce power consumption and reduce tool wear.
See also
First chapter contains the machining process characterisation by means of cutting forces.
Another possibility consists in measuring the cutting forces exerted on the insert holder.
Prior art closures have been known to be incapable of resisting these cutting forces.
This makes the cutting forces more constant with less chance for chatter.
Conventional razor blade cutting edges exhibit surprisingly high initial cutting forces.
This assures efficient transmission of cutting forces from the blade to the two support members.
The tool design gives a large support surface and optimal distribution of cutting forces.
Russia has begun cutting forces in Syria.
Avoid machining where the workpiece has poor support against the cutting forces.
This includes monitoring cutting forces and vibrations, for example.
Positive rake angle for good chip formation guarantees a smooth cut and low cutting forces.
Short cutting time, lower cutting forces and smoother running.
Simultaneously the chip formation becomes favorable and machining can occur with moderate cutting forces.
The cutting forces are borne by the shearing working elements ; and.
Explosion of the atomized fluid particles imparts mechanical cutting forces onto the target surface.
The cutting forces are symmetrically distributed, which limits the risk of jamming.
HSM conditions may thus be said to prevail when the cutting forces are diminishing.
First, a geometry that reduces cutting forces while reducing horsepower requirements is desirable.
As metal cutting occurs, three orthogonally related cutting forces are generated.
Low cutting forces Stable cutting edge Suitable for universal application Good self-centring capability.
From this first geometric modeling, modeling of cutting forces was established.
The cutting forces push-down the workpiece towards the table, thereby nearly eliminating pre-splitting.
In conventional machining, the cutting forces increase with increasing cutting speeds.
Moreover, spectral arrays appear at frequencies greater than 9 kHz on spectrum of cutting forces.
In the case of a conventional laser system, thermal cutting forces are imparted onto the target 1157.
The high-tech geometry enables perfect centring, efficient swarf fractionating and low cutting forces.
Fig . 4 is a view showing resultant cutting forces acting respectively on the inserts illustrated in Fig . 1 ;.
The explosive forces from these atomized fluid particles impart mechanical cutting forces onto the target 57.
Cermet, finishing to medium machining Low cutting forces Good chip control High surface quality CCMT 09T308.
The cutting edge 59 may be inclined, as shown here, to reduce the corresponding cutting forces.
Most geometries incorporate an ultra-sharp cutting edge to reduce cutting forces and improve surface finish.
You'll also be interested in:
Examples of using Cutting
Show more
When cutting a branch that is under ten
Never operate without cutting coolant or paste
Cutting threads to profile girders not required
Examples of using Forces
Show more
There are no external forces applied on the device
Forces nouvelles revenues from taxation of cocoa
The person who forces you is not me
