Examples of 'depth of cut' in a sentence
Meaning of "depth of cut"
Depth of cut: Refers to the measurement of how deep a tool penetrates or cuts into a material such as wood, metal, or plastic
How to use "depth of cut" in a sentence
Basic
Advanced
depth of cut
A small amount of depth of cut can be obtained by.
Do not attempt to make an excessive depth of cut.
Adjust the depth of cut as described above.
Raising saw will decrease depth of cut.
The depth of cut is zero at this point.
Set foot to maximum depth of cut setting.
The depth of cut can be set in millimetres.
Lowering saw will increase depth of cut.
Determine the depth of cut as described before.
This adjustment sets the depth of cut.
The depth of cut seems to be extremely shallow.
Use stopper pole to adjust depth of cut.
Uneven depth of cut side to side.
The window corresponds to a predetermined depth of cut.
Improper depth of cut setting on saw.
See also
Correlation of width of cut and maximum depth of cut.
Sufficient feed and depth of cut must be used.
Mm depth of cut when using guide rail accessory.
You can read the depth of cut by.
Adapt the depth of cut to the millimeter using.
Board thickness does not match depth of cut scale.
Adjust depth of cut using depth adjustment knob.
Be sure to readjust shoe for proper depth of cut.
Set depth of cut to full depth.
Setting mortiser for depth of cut.
Adjust depth of cut using depth adjustment lever.
Adjust guard to desired depth of cut.
Use a shallow depth of cut when cutting thin.
Adjustment screw for depth of cut.
Adjusting the depth of cut helps minimize kickback.
The sanding frame helps to control depth of cut.
Adjust to the proper depth of cut by loosening and re.
Corelation of width of cut and maximun depth of cut.
Do not change the depth of cut while planing.
The depth of cut can be set in millimetres by turning the.
Determine required depth of cut and final thickness.
Thus one can control the depth of cut.
Next the depth of cut is selected.
They bear no relation to the depth of cut needed.
Improves the depth of cut and greater resistance.
Lock the cutting depth clamp to secure depth of cut.
An accurate and regular depth of cut was successfully achieved.
The depth of cut may be adjusted by turning the handle.
Feed rate and depth of cut.
Set the depth of cut prior to installing the router.
Adjust the depth of cut.
Use the depth of cut scale for standard depths.
The shoe will adjust to limit the depth of cut.
Add the desired depth of cut to the starting position.
Lower the saw head to the desired depth of cut.
