Examples of 'diameter of the holes' in a sentence
Meaning of "diameter of the holes"
diameter of the holes ~ this phrase refers to the measurement of the width of openings or cavities. It is commonly used in the context of describing the size or dimensions of a hole or opening, such as in manufacturing, engineering, or construction
How to use "diameter of the holes" in a sentence
Basic
Advanced
diameter of the holes
Matches the diameter of the holes in the body.
Scanning electron microscopy was used to size the inner and outer diameter of the holes.
The diameter of the holes varies from one ring to another.
These bolts should be the diameter of the holes in your saw base.
The diameter of the holes decreases over the plates connected in series.
Only the amount of perforation and the diameter of the holes therefore influence efficiency.
The diameter of the holes may be larger than the width of the grooves.
These mm-values refer to the diameter of the holes.
The diameter of the holes must be appropriate for the pitch and separation technique.
Special sprays . you can adjust the diameter of the holes.
The diameter of the holes on the extruder was 1 mm.
Advantageously, distance D over which the diameter of the holes decreases is relatively short.
The diameter of the holes is 1 mm.
I am guessing Derek 's, since the blade matches the diameter of the holes on his body.
Matches the diameter of the holes in the body . I use it for my visual aids.
See also
The geometry and capillary diameter of the holes is described in Table 1.
The diameter of the holes 16 reduces as the metallic deposition takes place.
In the same way, the diameter of the holes must be proportionate.
The diameter of the holes 12 is slightly greater than that of the pins 8.
Warning, the diameter of the holes is important!
The diameter of the holes may be on the order of about 1 to about 1.5 mm.
Most of the time, the diameter of the holes should be around 30 mm.
The diameter of the holes 51 is preferably about 1 mm.
Preferably, the diameter of the holes in the annular mould is at most 10 mm.
The diameter of the holes may be 300 nm for example with a depth of 1 um.
Preferably, the diameter of the holes 36 is in the range between 2 mm and 4 mm.
The diameter of the holes 40 is less than that of the plungers 9 of the carpules 1.
You'll also be interested in:
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
Examples of using Holes
Show more
Great holes have been cut in the earth
Always remove the lid or put holes in it
They cut holes behind every cabinet
