Examples of 'diameter of the tube' in a sentence
Meaning of "diameter of the tube"
{"a": "diameter of the tube"} ~ "Diameter of the tube" refers to the measure of the distance across the circular cross-section of a tube or pipe. It is typically expressed in units such as inches or millimeters and is an important parameter when determining the flow characteristics and capacity of a tube or pipe system
How to use "diameter of the tube" in a sentence
Basic
Advanced
diameter of the tube
Is the inner diameter of the tube used.
Diameter of the tube decreases.
Where d is the inner diameter of the tube.
The diameter of the tube is measured in eighths of an inch.
Defines the diameter of the tube.
The diameter of the tube is larger for a reflex sight system.
Is the outside diameter of the tube.
An outer diameter of the tube may correspond to an outer surface of the tube.
It depends on the diameter of the tube.
The inner diameter of the tube conditions the silica production capacity.
Factor for decreasing the diameter of the tube.
Inner diameter of the tube.
This varies based on the diameter of the tube.
An internal diameter of the tube may narrow in the distal direction.
The box is five times the diameter of the tube.
See also
The diameter of the tube will be chosen according to the limit of the process.
Calculate the inner diameter of the tube in centimeters.
This method does not deform the outside diameter of the tube.
If desired the diameter of the tube can be adjustable.
Means can be provided for adjusting the diameter of the tube.
Length or diameter of the tube.
This square cross section exceeds slightly the diameter of the tube.
Measure the diameter of the tube.
The shrinkage of the tube is limited to the outside diameter of the tube.
Adjusts easily to the diameter of the tube by means of two screws.
This technique has the drawback of increasing the overall diameter of the tube.
It must also adapt to the diameter of the tube to be fixed and tightened.
The thickness of the wall is inversely proportional to the external diameter of the tube.
Length and internal diameter of the tube are variable and variably combined.
The length of the shell compared to the diameter of the tube inside.
Using the diameter of the tube to determine pressure can provide highly accurate readings.
Many MWNTs are included so that the diameter of the tube is wide.
Only the inner diameter of the tube A is different in the testers Tr.
Resistance to flow through a tube decreases as the diameter of the tube increases.
A is the diameter of the tube or the width of the square section ;.
This calibration step helps to precisely adjust the external diameter of the tube.
The flaring is a widening of the diameter of the tube along the entire circumference.
This helps to facilitate the calibration operation for the external diameter of the tube.
The inner diameter of the tube could be 5mm in the above case.
The diameter of this core determined the inside diameter of the tube to be produced.
Preferably, the diameter of the tube is larger after the pressure release valves 3.
The size of the glands should be suitable for the diameter of the tube used.
The diameter of the tube consequently increases, and the wall thickness decreases.
The diameter of the disc is slightly larger than the bore diameter of the tube.
The greater the diameter of the tube selected, the higher is its load capacity.
The volume of each pumping cycle is dependent upon the internal diameter of the tube.
In this manner, the wall thickness and diameter of the tube are simultaneously reduced.
Preferably, the wall thickness should be substantially half the diameter of the tube.
When the tube is twisted, an inner diameter of the tube tightens like an iris.
A more or less symmetric expansion occurs, thereby increasing the inner diameter of the tube 1.
You'll also be interested in:
Examples of using Tube
Show more
The telescopic tube must be tightly locked
Tube him while you have an airway
Replace with a new tube connecting piece
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
