Examples of 'dip switch' in a sentence
Meaning of "dip switch"
A dip switch is a small electronic device or component with multiple switches arranged in a row. It is used to configure or control the settings of electronic devices or circuits
Show more definitions
- A miniature switch designed to be attached to a circuit board to customize the behavior of the circuit.
How to use "dip switch" in a sentence
Basic
Advanced
dip switch
Dip switch selectable for sink or source.
The appropriate dip switch must be enabled.
An example of a manual electric switch is a dip switch.
The headlamp dip switch was foot operated.
Dip switch to set microphone sensitivity.
Checking according to dip switch setting.
Check dip switch settings on receiver.
I also like having the dim dip switch on the floor.
Ras dip switch settings figure.
Protocol and baud rate are shown due to the dip switch setting.
Dip switch configuration operation logic.
Remember to install the correct chart to match corresponding dip switch setting.
Refer to the dip switch chart for more information.
Then address your laser according to the dip switch assignment table.
The dip switch settings are incorrect in the remote control.
See also
Remember to turn off the power supply before checking the dip switch settings.
Set the dip switch with the power turned off.
The ring topology sets up with a single dip switch on only one of the modules.
Dip switch settings are only updated when the unit is turned on.
Each fanSync receiver can pair to five different transmitters with different dip switch codes.
If necessary make dip switch configuration before closing the control cover.
Follow the procedures below to remove the maintenance panel and set the Dip Switch.
Dip switch to change start mode in order to exactly march your automation software.
The marking of the CHIME dip switch is incorrect.
Verify dip switch settings on transmitter and receiver units are set the same.
Configuration of internal dip switch only SYSTEM.
The dip switch setting should be changed when the power is OFF.
Push the Reset button after changing the Dip switch.
Do not change the DiP Switch setting when the charger is operating.
The respective IRIG-Code is selectable by using the dip switch.
Dip switch position Description of use.
The conventional dip switch is adjustable on-site.
Dip switch to activate Control Room mute according to your layout.
More information on the position of dip switch 8 can be seen below.
One Dip switch for adress.
If the system is not defined, use the default dip switch setting position B.
Dip switch Rocker.
The alarm speaker may be activated or deactivated with the use of Dip Switch 8.
Dip switch selectable for sink or source max . voltage.
Set the position of dip switch 1 to ON and all others to OFF.
Dip switch SW1 is used to select the baud rate.
After check, return each bit of Dip switch to OFF position.
Instead, a dip switch can be set to disable that message from being sent.
You can set the mains frequency using the S3 dip switch.
Set dip switch 3 of the accessory module to ON.
DHW preheating function The function is enabled by setting dip switch 5 to the ON position.
IMPORTANT, set the dip switch before each individual programming procedure.
Off, Receiver enabled for rolling-code and programmable code transmitters selflearning and Dip Switch.
Always use the default dip switch setting ( position B ) if the system setup is not defined.
Examples of the setting component 37 include a dip switch.
You'll also be interested in:
Examples of using Switch
Show more
The floating switch is blocking in automatic operation
Opera never survived the switch to electric
Set the switch to the correct position
Examples of using Dip
Show more
I can not even dip my toe in a pond
Dip switch selectable for sink or source
We have gotta dip into the pensions
