Examples of 'draw ratio' in a sentence
Meaning of "draw ratio"
Draw ratio: A term commonly used in various industries, such as manufacturing or design, to refer to the ratio between the length and width of an object, structure, or component. It helps to maintain proportion and dimensions during the creation or editing of visual or physical elements
How to use "draw ratio" in a sentence
Basic
Advanced
draw ratio
A higher draw ratio leads to a stronger fibre.
The maximum biaxial draw ratio was low.
The draw ratio is generally from two to twenty times.
This ratio is referred to as the draw ratio.
Too high of a draw ratio tends to rupture a film.
The yarn is drawn close to its maximum draw ratio.
This higher draw ratio results in greater tenacity.
Teijin fails to teach anything about the draw ratio in the air gap.
The draw ratio was determined with the aid of marks.
The measured tensile strength was significantly lower than for higher draw ratio.
It occurs when the draw ratio exceeds a critical value.
Draw ratio is limited on the lower end to that which allows spinning to run.
Further increasing the draw ratio resulted in breakage of the film.
The ratio of final spacing to initial spacing identifies the linear draw ratio.
The effect of draw ratio is compared at each spinning speed.
See also
These properties can be achieved with a low final draw ratio in that direction.
The major draw ratio should be taken in the first stage.
Further the amount of draw production shrinkage decreases slightly as the draw ratio increases.
The draw ratio of the cutter bar is too large or too long.
A compression ratio can be defined that is analogous to the draw ratio defined for extrusion.
The overall draw ratio of the undrawn filament is preferably ten or more.
The speed of the roller controls the draw ratio and final film thickness.
The draw ratio to avoid surging for each yarn is determined and used.
Additional draw zones are optional and usually extend the total machine draw ratio slightly.
The upper limit on draw ratio is provided so as not to break the filament.
The thickness and the width of the product both diminished with increasing draw ratio.
We already learn a low draw ratio will not make a high stretchy resultant web.
The width and thickness variation was essentially similar to that encountered with a low draw ratio.
The relatively low draw ratio used allows the filaments to retain a very high elongation.
The speed of the nip rolls control the draw ratio and final film thickness.
Such a high draw ratio can result in a relatively high excess loss for the following reason.
Number of false twist inserted Draw ratio.
A high draft ratio means that the draw ratio after ejection from the spinneret is high.
The draw ratio may also be different in the MD and TD directions.
The tape was stretched to its ultimate draw ratio with the results shown in Fig.
The draw ratio in the air gap was about 7.
In alternative spinning configurations, definition of draw ratio changes.
The planar draw ratio is generally equal to or higher than 6.
Therefore, it is necessary to spin the fibers with a low draw ratio.
Therefore, a draw ratio that does not cause fiber whitening is preferable.
Therefore from a productivity point of view, a low draw ratio is also desired.
When the draw ratio is extremely increased, the pore size is enlarged.
As a result, the yarn could be drawn and twisted only at a low draw ratio.
With higher orientation, the draw ratio normally needs to be reduced.
In various embodiments, the amount of the working is determined by the relative draw ratio.
Preferably, also the applied draw ratio is therefore kept constant.
A fiber having a strength of more than 8 cN / dtex can be obtained by increasing the draw ratio.
Preferably, the actual draw ratio is within 5 percent of the predicted draw ratio.
At the same time, the polymer becomes fibers when the draw ratio is increased.
In this instance, the draw ratio remains constant, while the yarn speed is varied.
You'll also be interested in:
Examples of using Ratio
Show more
Gross enrolment ratio at secondary level percentage
Ratio of owned versus leased office space
See proper dilution ratio instructions on bottle
Examples of using Draw
Show more
I do not draw customers in such hard times
There is no one there for her to draw on
I do not desire to draw my sword in my own defence
