Examples of 'draw ratios' in a sentence
Meaning of "draw ratios"
Draw ratios: In engineering or design, draw ratios refer to the ratio between the length of the final product and the initial length in processes like extrusion or molding
How to use "draw ratios" in a sentence
Basic
Advanced
draw ratios
Preferred ranges of draw ratios so achieved are those previously specified.
The procedure described was carried out with various draw ratios.
The draw ratios of some of the films were calculated in the following manner.
In the process according to the invention varying draw ratios may be used.
The radial and axial draw ratios may be found empirically either through experiment or modeling.
Calendering may allow higher molecular orientation to be achieved by enabling subsequent higher draw ratios.
The drawing temperature and draw ratios are chosen depending upon the desired end use properties.
Calendering can allow higher molecular orientation to be achieved and enable subsequent higher draw ratios.
Fiber properties and maximum draw ratios are shown in Table IIIA.
Draw ratios were all equal to or less than 1.
Two-stage drawing allows higher draw ratios to be achieved.
Moreover, high draw ratios involve an increase in draw tension.
The present process can achieve draw ratios as high as 6.
Other draw ratios may be used, depending on the polymer blend composition.
For melt spinning operations, draw ratios of greater than two are preferable.
See also
Table 2 gives the dimensions of the billets for the corresponding nominal draw ratios.
However, at very large draw ratios there is a maximum in the curves.
Draw ratios are typically around 3 to 4 in each direction.
In general, however, greater draw ratios are desired for providing low shrinkage fibers.
Draw ratios below 2 often fail to produce'substantially non-spherical rubber particles.
Stretching is carried out with the draw ratios presented in Table 3.
Further these draw ratios are obtained in very well controlled, modern process equipment.
The yarn was drawn in a second step at a temperature of 153°C at various draw ratios.
The draw ratios and the characterization of the fibers so obtained are reported in Table 3.
The fluid filaments are drawn with draw ratios of maximum 35 according to its Example 1.
Draw ratios up to 20 were used for the MD orientation.
Their natural draw ratios are listed as " NDR " in Table C1.
Draw ratios of up to 10 are possible.
At higher draw ratios ( above 30 ) the change in geometry due to the extrudate drawing dominates.
With draw ratios of at least 4:1 the P conformation was significant.
Measure the draw ratios using an annealing temperature of 115°C.
You'll also be interested in:
Examples of using Draw
Show more
I do not draw customers in such hard times
There is no one there for her to draw on
I do not desire to draw my sword in my own defence
Examples of using Ratios
Show more
Ratios of key financial indicators regular resources
Verification of stress ratios using strain gauges
Some ratios in technical and vocational education
