Examples of 'dry solids content' in a sentence
Meaning of "dry solids content"
The amount of solid material present in a liquid substance after all water has been removed
How to use "dry solids content" in a sentence
Basic
Advanced
dry solids content
Dry solids content is a measure of the degree of dewatering.
After dewatering the sludge has a typical dry solids content of approx.
The dry solids content was determined by refractometric measurements.
Thus it would be desirable to utilise an adhesive having a much higher dry solids content.
Therefore the final dry solids content was limited to this level in this test.
The difference in weight before and after drying indicates the percentage of dry solids content.
The increase of the dry solids content is achieved by the addition of inorganic salts.
The nitrogen oxide emissions were observed to increase with increasing black liquor dry solids content.
The volume and the dry solids content of the bottom phase are reduced.
In addition, the effect depends on the scale of formation and dry solids content.
The dry solids content of each phase is measured according to the following procedure.
Alternatively, the amount of fat may be defined in terms of the dry solids content.
The same is true if the dry solids content after the press section decreases.
The ingredients were mixed to provide 33 wt % total dry solids content.
The rest of the dry solids content comprise mainly other carbohydrates and ashes.
See also
This pulp was rediluted to a dry solids content of 6 %.
The dry solids content and supersaturation of the solution were raised evenly during the evaporation.
Maltodextrin is then added to bring the dry solids content up to 15 % wt.
The effect of feed dry solids content on the membrane performance is presented in Table V.
Air dry metric tonne of pulp meaning dry solids content of 90.
High dry solids content of bark, by use of efficient presses or drying.
The eluate is evaporated down on a rotary evaporator to a dry solids content of 10 % wt.
The separation stage where the dry solids content is lower produces a potassium sulphate product.
The concentrated methanolic solutions are further concentrated to 5 % wt. dry solids content on a rotary evaporator.
Increasing the dry solids content prior to the step of re-circulating.
Concentrating the ferment obtained in step c to a dry solids content of at least 50 wt. %.
The dry solids content of the different portions was 14 % after hydrolysis.
The biological material may have a dry solids content of biological material of at least 20 %.
The amount of said components is typically more than 90 % of the dry solids content.
Milk with a dry solids content of 9 % by weight was inoculated with an S. diacetilactis culture.
The examples use calciumbicarbonate and the total dry solids content is maximally 37 %.
The dry solids content of cesium was 7 %.
The filler content in the stock was 38 % of the dry solids content of the stock.
The dry solids content of the black liquor was 65 %.
The final emulsion had a dry solids content of 71 %.
The dry solids content of the filter cake was 31 %.
Potassium sulphate crystals began to form at a dry solids content of about 40 wt. - %.
The dry solids content of such vinasse is about 3 to 16 % by weight.
It is possible to raise the dry solids content to about 1,0 % by sedimentation.
The dry solids content of a drinking water sludge is typically only about 0.2 %.
In a preferred embodiment, the solution is evaporated to a dry solids content of 75 to 90 % by weight.
Dry solids content of the lignin material introduced to the system is preferably between 40 and 90 %.
The final slurry concentrate was measured to have a dry solids content of 28.4 wt %.
The final dispersion had a dry solids content of 70 % and possessed a natural pH of 9.
Concentrating the fermentation broth obtained in step ( b ) to a dry solids content of at least 50 wt. %.
These reactors have a dry solids content of between 5 and 15 % in the biomass.
The starting material used was piggery sludge having a dry solids content of about 12 to 15 %.
The process as defined by claim 5, said dry solids content being greater than 20 % by weight.
The potassium salts begin to precipitate / crystallize when the dry solids content rises above 35 wt. - %.
You'll also be interested in:
Examples of using Content
Show more
On the product content and environmental release
Content management interfaces for web systems
Adjusts style and content when necessary
Examples of using Dry
Show more
Dehumidifier does not dry the air as it should
Let it dry completely before starting it up again
Dehumidifi er does not dry the air as it should
Examples of using Solids
Show more
The solids feared our metamorphic abilities
A sieve separates solids from used liquids
Solids liable to become liquid during transport
