Examples of 'enable signal' in a sentence
Meaning of "enable signal"
Enable signal refers to a command or communication sent to activate or enable a particular function, process, or device. It is commonly used in technology and telecommunications contexts
How to use "enable signal" in a sentence
Basic
Advanced
enable signal
The second multiplexer is controlled by a transparency enable signal.
Cancelling the enable signal on the controller is not sufficient.
These buffers transmit when they receive an enable signal.
Enable signal not required from the electrical utility.
A valve is blocked until an enable signal is received from a control station.
The enable signal received enables the operation of the segment.
Means for supplying said secure enable signal as input to said terminal.
The continuously generated beacon transmission is initiated in response to a beacon enable signal.
Means for supplying this secure enable signal to the input of the aforementioned terminal.
At least one wireless transmission is used to initiate the beacon enable signal.
The timing for outputting the enable signal may be established as desired by the user.
The row driver FETs are then enabled by taking the enable signal low.
The evaluation unit only gives the enable signal when the feedback circuit is closed.
The enable signal is provided when the shift length command reaches or exceeds a predetermined value.
The line c represents a write enable signal WE.
See also
The Enable signal then goes low to activate the row drivers.
Writing takes place after reception of an enable signal WE.
The address enable signal ALE must for its part be placed in a low state.
The operation to be monitored is assumed to receive an enable signal EN.
The VID refrains from generating the write enable signal while said coefficients are being received.
The write itself is done on a rising edge of the write enable signal WE.
These include the chip enable signal CE and the reset signal RST.
The ripple carry out RCO output is a horizontal line sample enable signal.
An enable signal val from the threshold estimator LVEST controls the decision device GATG.
The row driver FET is then enabled by taking the enable signal low.
Preferably, a coded enable signal is transmitted.
For expanding data, the clock gating information is applied to the read enable signal.
In other words, the enable signal is paired with its complement.
Relay is energized even if Run Enable signal is off.
Once the enable signal is provided, coding occurs as described above.
During a normal mode of operation the EPP enable signal EPPEN is low.
Although preferred, the enable signal is not necessarily a continuous signal.
In addition, the control interfaz supports an isolation device enable signal and a reset signal.
The writing enable signal WE is at state 1.
It should therefore be positioned during the active level of the enable signal / OE.
For example, signal EN is the enable signal of a cryptographic function.
An additional input of the circuit ET1 receives the enable signal VAL.
For example, to enable signal at activating of Start command complete the following.
In response to a match, a transmit enable signal is generated.
The hardware X-Ray Enable signal only functions in analog programming mode.
The last bit of IC3 is assigned with the drive enable signal BA.
Note, Functionality of the Start Enable signal is different from the Run Enable signal.
The header checking unit 46 is provided with a header enable signal.
A preferred procedure of coding the enable signal is Frequency Shift Keying ( FSK ).
The enable signal is supplied by microcomputer 52.
The signal RUN BIT corresponds, for example, to the enable signal of the fault detection function.
The enable signal is set to 1.
This is achieved using a FIFO enable signal I1 e.
The enable signal may comprise instructions to enable watchdog timer 226.
The second input receives an address enable signal ALE ( standing for Address Latch Enable ).
You'll also be interested in:
Examples of using Signal
Show more
Give me a signal when you want me to start
You have to use one signal at a time
Signal strength indicating connection between units
Examples of using Enable
Show more
To enable the report management proceed as follows
Select this option to enable automatic discovery
Enable the cable outlet that is pre
