Examples of 'engine pulley' in a sentence
Meaning of "engine pulley"
engine pulley: An engine pulley is a component in a machine or vehicle that is connected to the engine and helps transfer power from the engine to other parts of the system, such as the wheels or other mechanical components
How to use "engine pulley" in a sentence
Basic
Advanced
engine pulley
Place belt onto engine pulley in groove.
Disconnect motion drive belt at engine pulley.
Loose engine pulley or pump flywheel.
Loosen the setscrew on the engine pulley.
Loose engine pulley or compressor flywheel.
Place the belt on the engine pulley.
Align the engine pulley with the pump flywheel.
Remove belt from engine pulley.
Loose engine pulley or Retighten pulley and flywheel.
Slide the belt free of the engine pulley.
Reposition and secure the engine pulley belt guard, and re-install the belt cover.
Slacken the two belt guides at the engine pulley.
Retighten the engine pulley setscrew.
Remove the drive belt from the engine pulley.
Remove belt downward from engine pulley and around electric clutch G.
See also
Roll the auger belt off the engine pulley.
An engine pulley ; a generator pulley ; and a belt connecting the engine pulley to the generator pulley.
Work rear of belt below engine pulley and out.
Pull betttoward front oftractor and roll belt around electric clutch and onto engine pulley G.
Guide rear of new belt under engine pulley and back above clutching arm.
The belt should not go around the engine pulley.
Check alignment . Loose engine pulley or compressor flywheel.
Remove the belt from the forward engine pulley.
Place drive belt ( Q ) into engine pulley groove before installing onto engine shaft.
Slide the belt free of the reverse belt guides and engine pulley.
Remove the hex screw securing the engine pulley keeper rod to the frame.
The belt must be centered over the grooves on the flywheel and engine pulley.
On manual PTO units, re-install the engine pulley keeper rod and the PTO cable.
Ensure belt is routed correctly around idler pulley and seated properly in engine pulley groove.
Work the belt off of the engine pulley ( 6 ) and around the.
The forward idler belt will not clear the belt keepers near the engine pulley.
Work the belt onto the engine pulley ( 6 ) and under the belt guide 7.
Install new belt by first routing belt under the engine and around engine pulley Y.
Install belt on engine pulley ( M ), in belt keepers G.
Pull belt toward front of tractor and roll belt onto engine pulley E.
Remove old belt by slipping off engine pulley first then.
Route new belt through idler assembly to blade adapter/ engine pulley.
Remove mower belt from engine pulley M.
Place V part of belt into grooves on engine pulley and front.
Remove belt downward from engine pulley E.
Take off the belt from the engine pulley 1.
Install previously removed washer and bolt ( O ) and secure engine pulley onto engine.
Remove the belt ( c ) from around the tractor 's engine pulley and idler pulleys.
Remove the two rear guard bolts to remove the engine pulley cover . See Figure 11.
Install previously removed bolt ( O ) and secure engine pulley onto engine.
Install new forward ( inside ) V-belt to engine pulley first.
You'll also be interested in:
Examples of using Pulley
Show more
Rotate the pulley to be sure it spins freely
Check for a damaged belt or damaged pulley
Pulley and idler not in correct adjustment
Examples of using Engine
Show more
I started the engine and sped off
An engine shall be remapped prior to a test cycle if
Always stop the engine before unclogging
