Examples of 'film surface' in a sentence
Meaning of "film surface"
Film surface: refers to the outer layer or coating of a film. It is the visible part of the film that is exposed and can be seen. It may encompass the texture, appearance, or characteristics of the film's outermost layer
How to use "film surface" in a sentence
Basic
Advanced
film surface
Keep jet perpendicular to the film surface.
A film surface may be characterized by measurement of surface roughness.
No free oil was observed on the film surface.
Photoinitiators excited at the film surface do not participate in polymerization.
No separated oil was observed on the film surface.
Film surface treater.
This minimizes resputtering of the film surface.
Mineral oil is applied to the film surface to remove surface scratches.
A water droplet is placed on the film surface.
Mineral oil is applied to the film surface to remove surface scratched.
There was no indication of permanent marking on the resultant film surface.
One method of microfibrillating a film surface is with fluid jets.
Only a small amount of separated oil was apparent on the film surface.
This protocol produced a reproducible film surface and reproducible adsorption.
This would indicate a very smooth and uniform film surface.
See also
The matching film surface is corona treated over its entire área.
Controlled modification of aluminum thin film surface roughness.
A film surface could easily be damaged during application of this optical film.
No oil was seen on the film surface.
The surface tension of the film surface and surface electrical properties were also improved.
This holds true throughout the film surface.
The formation of donor defects at the film surface is favored above a critical film thickness.
Excess gloss results in light reflection from the film surface.
The ink needs only to exist on one film surface to prevent a seal from occurring.
This working step removes excess pigment from the film surface.
This dirt can settle on the film surface and interfere with the use thereof.
Agitation is important to keep fresh chemistry in contact with the film surface.
The dense surface is shown as a continuous dense film surface punctuated by a myriad of pores.
This procedure ultimately gives rise to a uniformly continuous coating film surface.
Metallized film surface energy Is affected by temperature and storage life.
Lightly built up film surface.
Therefore both spectra confirm the presence of polybutylmethacrylate and phenylcarboxylic groups on the film surface.
Then the smoothness of the coating film surface was measured.
The mean fibril length is estimated by examining scanning electron photomicrographs of the film surface.
Residual powder is removed from the metallized film surface using a suitable solvent.
Rotational coating is effected to obtain an excellent smoothness of the coating film surface.
Coating appearance The appearance of the coated film surface was evaluated by visual observation.
Evacuation plans and safety signs can be printed directly on the film surface.
As a result, the sausage film surface was found heavily wrinkled.
A lower contact angle represents a greater degree of hydrophillicity or film surface wettability.
Thus, the slippage of the film surface is not conducted smoothly.
A lower contact angle represents a greater degree of hydrophilicity or film surface wettability.
Thus, the reversing of the film surface is achieved very smoothly.
A weeping pouch exhibits small quantities of the pouch contents on the film surface.
Melt fracture is a measure of film surface uniformity, appearance and strength.
These sensors work on the principle of reflecting light from the film surface.
If the film is a uniform film, the film surface may be a hydrophilic surface.
This is most likely caused by the nonpolar lipids aggregating on the lipid film surface.
Rubber o-rings were glued to the film surface using epoxy or cyanacrylate glue.
The whiskers of this nanostructured composite film are uniaxially oriented normal to the film surface.
You'll also be interested in:
Examples of using Film
Show more
The film has not started yet
We are finishing the film about that invention
Film can be applied without disconnecting pump
Examples of using Surface
Show more
An uneven surface increases the risk of overturning
Where ϑ is the measured test surface temperature
All feasible surface and subsurface ECVs
