Examples of 'gel time' in a sentence
Meaning of "gel time"
Gel time: The period required for a gel or substance to solidify or reach a gel-like consistency after mixing
How to use "gel time" in a sentence
Basic
Advanced
gel time
Gel time is measured in seconds at a given temperature.
Curing was monitored by means of standard gel time equipment.
The gel time was defined as initial reactivity.
The curing was monitored with the gel time equipment.
Gel time can be regulated with parabenzoquinone.
Smoke generation was a visual observation during testing of gel time.
The gel time is recorded in seconds.
A slight lowering of the pH brings about radical changes in gel time.
This gel time was too fast.
Reaction profile was followed in terms of cream time and gel time.
The gel time was then measured.
Increase gel time.
The gel time was less than one second.
The mixer must be changed after the gel time has elapsed.
Gel time for each run is also provided.
See also
The mixture has a gel time of a minute and thirty seconds.
Gel time measurement of various peroxides.
This influences the reactivity providing an ability to control the gel time.
The gel time is measured as follows.
This leads to a difference in potential which makes it possible to determine the gel time.
A slower gel time translates to advancement in molecular weight.
These are filled epoxies that have moderate mixed viscosity and a long gel time.
The gel time were then measured.
The tests were conducted to determine the blend effects on gel time and exothermic reaction.
The gel time of the resulting prepolymer was tested again.
Leave your mouth open for half a minute to give the gel time to work in.
Gel time taken from these powders are listed below.
These examples further demonstrate that inhibitors can be used to tune the gel time.
The gel time of a small portion of the gelcoat is determined.
The table below demonstrates that gel time changes with variety and amount of catalyst.
A high gel time corresponds to a high stability of the adhesive formulation.
This result indicates that formulations with a low gel time drift tendency can be obtained.
Gel time was determined in a thin film on a heated metal gel plate.
This minimum corresponds to a gel time slightly above that of PVC.
This gel time is a measure of the cure speed of the adhesive.
Measurement of the VNC gel time under UV.
The gel time of the aqueous silicate solutions was then measured.
The samples were tested for gel time using the following procedure,.
The gel time then also depends on the thermolysin concentration used.
Table 1 shows the gel time at various temperatures.
The gel time is the time measured at the maximum vibration damping point.
In addition, resins can be obtained which exhibit a reduced gel time drift tendency.
Between gel time tests the blender is disassembled and thoroughly cleaned.
The composition may, optionally, further comprise a curing promoter to decrease the gel time.
During gel time measurement smoke was observed and unpleasant odor was found.
Furthermore, using an acetoacetamide compound may result in a further decrease of the gel time drift.
The value of the gel time made clear that there is nearly no crosslinking.
Record number of seconds to melt and number of seconds for gel time ( cure time ).
Gel time and hot plate melt flow were tested on the powder coating.
This method involves measuring the peak exotherm, the time to peak, and the gel time.
You'll also be interested in:
Examples of using Time
Show more
Spent a lot of time with the ladies
Time and tide wait for no man
A woman needs time to think things over
Examples of using Gel
Show more
The gel pads need to be changed periodically
Colourful silicone gel design to the front
Gel is essential when things get complicated
