Examples of 'hex head' in a sentence
Meaning of "hex head"
Hex head describes a type of fastener or bolt that has a six-sided head with hexagonal recesses or indentations. It is often used when discussing hardware, tools, construction, or mechanics, referring to the specific shape or design of the head of a screw, nut, or bolt that requires a hexagonal wrench or socket for installation or removal
How to use "hex head" in a sentence
Basic
Advanced
hex head
Leave the hex head screw in place.
Hex head close tolerance screw.
Replace and tighten hex head bolts.
Hex head socket wrench.
Shoulder washer and hex head pointed screw.
Where not indicated all bolts are hex head.
Remove two hex head screws.
Hex head self tappers.
Do not over tighten the hex head screw.
Vanode hex head fittings.
Fasten tightly with slotted hex head screws.
A hex head configuration is shown.
Do not loosen or remove adjacent hex head screws.
Unscrew the hex head screws from the top hinges.
The precision is amply sufficient for making an hex head.
See also
Remove the slotted hex head screw from the grass.
Hex head screws.
Install the second hex head screw into the hole.
Only use filters with a groove on the tightening hex head.
Install one of the hex head screws into the hole.
Of the thrust piece to the column by means of a hex head wrench.
Insert the three hex head screws from the bottom.
Place the flat washer and lock washer on the hex head.
Unscrew the hex head screws from the rollers and remove.
Install the foot assembly to the frame using the short hex head.
Remove the hex head hinge screws from handle side and.
Adjust the belt tension with the hex head set screw until.
Remove the hex head screws from handle side and move.
Keeping the spindle lock depressed then unscrew the hex head bolt.
Custom designed hex head has more biting edges than screws.
Press the spindle lock until it engages and tighten the hex head bolt clockwise.
The bolt hex head should be on the opposite side of protruding hub center.
Then tighten the two inner hex head screws to set the angle.
These hex head pointed screws are used only to attach this mounting bracket.
Screw the new lock nut onto the hex head cap screw and tighten securely.
Insert hex head bolts with flat washers through the saw base and.
A deep offset sill may require a longer adjusting bolt than the standard hex head bolt provided.
Transfer two hex head screws from top corner of cabinet to holes left.
Slide the guard into slot provided and tighten hex head screws with hex wrench included.
Loosen the two hex head screws and remove the lower front panel.
Place the release cam bushing and the release handle over the hex head cap screw.
The screws were inserted with a hex head screwdriver adapted to a calibrated torque meter.
Insert handle screw into hole located above trigger switch and seat hex head into hole.
Use the four short hex head bolts and four hex nuts to secure.
Heavy duty anchor for high performance in concrete, hex head.
Remove the hex head screws joining the connecting rods to the drive wheels.
Attach the two handle pieces using four hex head screws as shown in figures F and G.
Make sure the hex head lines up with the clutch drum inside the flange housing.
Using the hex key and the internal hex head screw, removed.
Locate the four hex head screws located on the corners of the back panel.
