Examples of 'hole diameter' in a sentence
Meaning of "hole diameter"
The phrase 'hole diameter' refers to the measurement of the width or size of a hole, typically in a circular or cylindrical object. It is used to describe the dimension of an opening or cavity, indicating how wide or narrow it is. The term is commonly used in engineering, construction, and manufacturing contexts, where precise measurements are essential for proper fitting or functionality
How to use "hole diameter" in a sentence
Basic
Advanced
hole diameter
The incoming hole diameter on auxiliary terminal.
Bit rotation speed as a function of hole diameter.
Predrilled hole diameter too small.
Hole diameter selectable depending on the material requirement.
The área is estimated from the hole diameter.
Hole diameter of a driving bolt for serrated bar.
Check the arbor hole diameter of the blade before.
The two nozzles have the same hole diameter.
The influence of drill hole diameter on sublevel stoping operation.
Hole diameter can be designed for a given range of catalyst liquid.
Decreases and widenings of the hole diameter are clearly observed.
The hole diameter can be predetermined according to the prosthesis diameter.
The resulting ratios of thickness to hole diameter are also listed.
This large hole diameter is important to ensure that blocking is minimised.
The hole has an inner wall with a predetermined hole diameter.
See also
Component versus hole diameter for constant incident power.
Dimensions the nominal size of the drilled hole diameter and length.
Rivet hole diameter.
Spring pins have a body diameter which is larger than the hole diameter.
Centre hole diameter.
The conventional effect in the form of splinters increases if the hole diameter increases.
Cord hole diameter.
The implant cavity is formed by expanding the hole diameter in several stages.
In practice the hole diameter and hole spacing will be a compromise.
Only flow regulating valves with the same hole diameter should be combined.
The hole diameter must match the back flange without play.
Wheels with the largest centre hole diameter shall be included in the test.
The hole diameter must match the tool spindle without play.
Take perforated disc with required hole diameter out of the storage compartment.
The separate approximations are then combined to obtain a more accurate indication of the hole diameter.
The mounting hole diameter must fit the mounting flange without play.
This value determines the attainable height of the collar for a given hole diameter.
Another effect of the hole diameter not being constant with depth is discussed here.
Both compounds exhibited similar trends in aerosol purity with increasing hole diameter and porosity.
Use the correct side for the hole diameter of the blade you intend to use.
The hole diameter can be further increased by using the same drilling and milling cutter.
Number of punching holes and hole diameter Available paper size.
Blade centre hole diameter Blade rotational speed at maximum allowable engine speed Thread.
If not, just increase a bit the hole diameter.
Recommended dimensions for hole diameter and lenght of engagement are available at DESIGN GUIDELINES.
Check manufacturer 's fitting specifications for proper hole diameter.
Screw size Pilot hole diameter Clearance hole.
Remove the unit from the wall, make a hole diameter.
Pilot hole diameter Screw size Soft wood Hard wood.
Pedicular screws ' pullout resistance was also inversely proportional to the pilot hole diameter.
Therefore, the hole diameter tends to be reduced at the exit side.
Generally, if the dynamic fluid resistance gradient increases, the hole diameter is decreasing.
As the sparger hole diameter decreases, gas flow distribution improves.
Alternatively, the alarm condition can be based on the calculated hole diameter approximation.
The hole diameter is typically well below 1 mm, sometimes even down to a few micrometers.
You'll also be interested in:
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
Examples of using Hole
Show more
So does that giant hole in the wall there
The hole of the steam spout is clogged
Cut the piping hole sloped slightly
