Examples of 'hole position' in a sentence
Meaning of "hole position"
Hole position refers to the specific location or placement of a hole. It is commonly used in the context of construction, engineering, or manufacturing, where precise hole positions are important for proper assembly or installation. The term can also be used in sports, particularly in golf, where the hole position determines the difficulty and challenge of a particular golf course or green
How to use "hole position" in a sentence
Basic
Advanced
hole position
Mounting hole position below the unit.
Determine the wall hole position.
Mark the hole position on the gate.
The drill bit has to be placed accurately onto the drill hole position.
Defines the hole position from image border.
Route the indoor tubing and the drain hose to the required piping hole position.
Hole position prossing.
Bracket is attached in the upper hole position at the factory.
Mark opening hole position and dimensions with the help of a ruler and a square.
With a pencil, mark the middle hole position.
Mark the intended hole position using a hammer and centre punch.
To ensure accuracy, mark the intended hole position.
Adjust the servo horn hole position and linkage so both are parallel.
Hole position * Middel high Left high Right high.
This design has raised concerns with the hole position tolerance capability of the manufacturing plants.
See also
Special hole position design, easy maintenance, no need to remove the entire back cover.
To ensure accuracy, mark the intended hole position using a hammer.
Mark the intended hole position using a hammer and centre punch to ensure accuracy.
When the hole depth reaches approximately 5 mm, the hole position can be determined.
Correct hole position of the shackle on the KIBU.
Fig . 8 is a view showing a setting of a hole position.
Correct hole position of the shackles on the KBUMP.
The superior performance of such a hole position is shown in Example 11.
Correct hole position of the shackle on the KLIFT.
Now measure a point 100 mm aft of each hole position.
Mark the hole position and drill it, initially slightly lower than marked.
Accordingly, it is possible to designate the hole position with reference to the displayed position.
Hole position tolerances are especially important . ”.
One hole position correlates to an adjustment of 0.5 mm.
You'll also be interested in:
Examples of using Position
Show more
Then position the unit as shown below
Verify the correct position of the gasket
Try to position cages out of direct sunlight
Examples of using Hole
Show more
So does that giant hole in the wall there
The hole of the steam spout is clogged
Cut the piping hole sloped slightly
