Examples of 'inhibitor concentration' in a sentence
Meaning of "inhibitor concentration"
inhibitor concentration - The amount or level of a substance that suppresses or hinders a chemical or biological process. It is commonly used in scientific research or industrial settings
How to use "inhibitor concentration" in a sentence
Basic
Advanced
inhibitor concentration
Inhibitor concentration was measured using gas chromatography.
The condition may be product inhibitor concentration.
The inhibitor concentration is shown in micro molar.
Method for determining a scale inhibitor concentration in a sample.
The inhibitor concentration determined by the above method may therefore be underestimated.
X is the logarithm of the inhibitor concentration.
Any given competitive inhibitor concentration can be overcome by increasing the substrate concentration.
Determination of the minimal inhibitor concentration.
Data is plotted as inhibitor concentration versus percent of enzyme control.
The radioactivity incorporated was plotted as a function of the inhibitor concentration.
Corrosion inhibitor concentration.
The radioactivity incorporated is plotted as a function of the inhibitor concentration.
Data may be plotted as inhibitor concentration versus percent of enzyme control.
The composition is preferably diluted with water to a satisfactory inhibitor concentration.
Combustion inhibitor concentration.
See also
It is to be noted that dosage values may vary with FXa inhibitor concentration.
A method to quantify the inhibitor concentration in a give inhibitor preparation can be found in Ex.
Surprisingly their long bath lives are not decreased by this reduction in inhibitor concentration.
Antiscale treatment efficiency depends on minimal inhibitor concentration and product release rate in fluids downhole.
The inhibitor causes the enzyme activity drop which is dependent on the inhibitor concentration.
X is inhibitor concentration and Y is the response being inhibited.
Phosphate incorporation was determined at each inhibitor concentration by scintillation counting.
At this inhibitor concentration the inhibitor-bound enzyme is in equilibrium with the inhibitor-free enzyme.
Control cultures are treated with DMSO equivalent to the inhibitor concentration.
The inhibitor concentration is stated in terms of mg / L of its sodium salt.
The Ki values were determined from the rate data as a function of inhibitor concentration.
The inhibition percentages calculated for each inhibitor concentration are calculated in the following manner,.
The Ki values are determined from the rate data as a function of inhibitor concentration.
The effect of each inhibitor concentration was calculated and IC50 values can be generated.
Results are plotted as CPM against inhibitor concentration.
The effect of each inhibitor concentration can therefore be calculated and IC50 values generated.
In another aspect, the condition is product inhibitor concentration.
The inhibitor concentration is 15 ppm ( of active material ) relative to the final mixture.
The percent inhibition values were determined at an inhibitor concentration of 10 µM.
Antagonist activity is indicated as inhibitor concentration required for 50 % inhibition of specific calcium increases.
These samples were analyzed for nicotine, cotinine and inhibitor concentration.
One typical minimal CuSO4 inhibitor concentration of 2 x Trx concentration ( or Trx equivalence ).
Log dose / response curves were constructed using a range of inhibitor concentration.
The percent inhibition at inhibitor concentration [ I ] was calculated as, EPMATHMARKEREP where.
That is, they exhibit complete inhibition of the protease at the lowest inhibitor concentration.
The HIV H9 cell assay measures the inhibitor concentration required to suppress HIV-1 virus replication.
The IC50 was evaluated from the rate data as a function of inhibitor concentration.
The inhibitor concentration was 50 mM.
Ki values were determined from rate versus . inhibitor concentration profiles.
The eight inhibitor concentration employed ranged from 10 µM to 3 nM ( from high to low concentration ).
These conditions include reagent concentrations, temperature, inhibitor concentration or enzymatic activities.
Lowest inhibitor concentration ( µM ) that gave greater than 20 % inhibition or lowest concentration tested.
IC50 values are determined by interpolation from plots of relative fluorescence vs inhibitor concentration.
Dose response curves were obtained and Inhibitor Concentration ( IC ₅ ₀ ) values calculated.
The CC50 values for the compounds presented were greater than the highest tested inhibitor concentration.
You'll also be interested in:
Examples of using Inhibitor
Show more
The malfunction to the inhibitor chip is an aberration
The inhibitor will kill her hunger
Pimaricin is a mould inhibitor for cheese rind
Examples of using Concentration
Show more
We will get some concentration camp clothes
Concentration of economic power in the supply chain
There is a higher concentration of blood at the knee
