Examples of 'inhibitor concentrations' in a sentence
Meaning of "inhibitor concentrations"
inhibitor concentrations: This term pertains to the levels or amounts of substances that decrease the rate of a chemical reaction
How to use "inhibitor concentrations" in a sentence
Basic
Advanced
inhibitor concentrations
A range of enzyme and inhibitor concentrations were used.
The experimentally obtained values of enzyme activity then are plotted against the inhibitor concentrations used.
A minimum of four inhibitor concentrations for each compound are performed in each assay.
Control cultures are treated with concentrations of DMSO equivalent to the inhibitor concentrations.
A minimum of four inhibitor concentrations for each compound may be performed in each assay.
Log dose / response curves were constructed using a range of inhibitor concentrations.
The inhibitor concentrations used in each test class are indicated in Tables I and II.
Co-administration of protease inhibitors with rifampicin substantially decreases protease inhibitor concentrations.
Inhibitor concentrations in Table 3 show the amount of active ingredient present.
Inhibition constants were determined from the Lineweaver-Burk plot data with at least five inhibitor concentrations.
Enzyme activity was determined over a range of inhibitor concentrations to establish an IC50 value.
Protease inhibitor concentrations may decrease ( as observed with lopinavir / ritonavir ) or increase.
The IC50 value is calculated from the inhibition values of a series of inhibitor concentrations.
The potentiation effect was averaged for the inhibitor concentrations and is summarized in Table 2 below.
The IC50 for each inhibitor was obtained by plotting the remaining activity versus inhibitor concentrations.
See also
Both substrate and inhibitor concentrations were varied and the K ; calculated ( see Table 3 ).
For each compound, assays as above were done for between 3 and 8 different inhibitor concentrations.
In this incubation step, the highest and lowest inhibitor concentrations were 10 µM and 0.5 nM respectively.
Percent inhibition and IC50 were calculated using peptide-dependent percent turnover at given inhibitor concentrations.
The results are expressed in the minimum inhibitor concentrations ( MIC -- ug / ml ).
Experimental design, Reaction velocities are measured at different four ATP, substrate ( histone ) and inhibitor concentrations.
Example 4 Determination of IC50 values, using 7 different inhibitor concentrations at factor 2 intervalls,.
You'll also be interested in:
Examples of using Concentrations
Show more
Plasma concentrations are similar in males and females
Found in highly elevated concentrations in top predators
Concentrations in volume per cent on wet basis
Examples of using Inhibitor
Show more
The malfunction to the inhibitor chip is an aberration
The inhibitor will kill her hunger
Pimaricin is a mould inhibitor for cheese rind
