Examples of 'inlet fitting' in a sentence
Meaning of "inlet fitting"
a device or component used to connect or attach an inlet to another object or system
How to use "inlet fitting" in a sentence
Basic
Advanced
inlet fitting
Water inlet fitting for connection of water supply.
Attach nipple adapter to inlet fitting on the unit.
The inlet fitting is in this case a male fitting.
The inlet filter is inside the inlet fitting.
Make sure washer in inlet fitting is clean and in good condition.
All XPi pumps are supplied with their inlet fitting.
Disconnect the large inlet fitting at the bottom side of the heater.
Take the filter out from the inlet fitting.
Remove the air inlet fitting at the bottom of the gun handle.
Press the filter bag connection firmly on to the inlet fitting.
Remove the air inlet fitting from the bottom of the gun.
Reattach the high pressure hose to the material inlet fitting.
Thread the air inlet fitting into the air flow adjustment knob.
Attach the air hose to the relocated air inlet fitting.
The inlet fitting as this may prevent water from entering the inlet valve.
See also
Attach the suction hose to the inlet fitting on the container.
Be sure to direct the incoming hard water supply to the softener valve inlet fitting.
It is good practice for yachts to use a hull inlet fitting with an integrated strainer.
Check the inlet fitting seal is present, and in good condition.
Press the disposal bag connection firmly on to the inlet fitting.
Water inlet fitting allowing for the connection of the primary pipe ;.
Take care not to lose the seal from the inlet fitting.
Unscrew burner inlet fitting from burner manifold see Figure 4.
Carefully remove the filter bag connection from the inlet fitting.
Further modifications of the parameters of the inlet fitting can provide for the desired K-Factor.
Carefully remove the disposal bag connection from the inlet fitting.
The inlet fitting 8 connects the coiled tubular filter 12 to the fluid to be filtered.
Grasp cardboard collar and slide rubber seal onto inlet fitting on top cover.
The aforementioned inlet fitting 22 is connected to the proximal end of the proximal tube section 34.
Purge gas / compressed air inlet fitting here.
Put the inlet fitting, half-flanges and screws onto the side where the plug is.
The gas ballast valve is located beside the handle, opposite the inlet fitting.
According to the preferred embodiments, the inlet fitting 16 is provided with a radially projecting boss portion 17.
Take off the 2 half-flanges and the inlet fitting.
This inlet fitting 31 is equipped with a constant flow reducer 32.
Carefully shape tube and attach to gas inlet fitting see Figure 6.
Thus, the inlet fitting 25 is not designed to create a compression fit with the containers 14.
Carefully remove the waste bag connection ( 1 ) from the inlet fitting.
Seecure a supply hose to the quick-release water inlet fitting ( 12 ) using a general-purpose gardening.
The assembly 10 is adapted to receive an internal heat transfer fluid through the inlet fitting 22.
The inlet hose 20 is provided with an inlet fitting 118 which includes a strainer to remove particulates.
A stop surface 17 can be provided as part of the inlet fitting 16.
Rotatable Inlet Fitting Inlet can be rotated 360 degrees for easy access 4.
INSTRUCTIONS FOR USE Connect the air hose to the inlet fitting ( 1 ) on the gun.
In operation, the cooling liquid enters the water box 36 via the inlet fitting 44.
Extending upwardly and in fluid communication with the inlet fitting 24 is impeller 36.
Connect a clean, dry, filtered air supply to air inlet fitting 13.
In the preferred embodiment of the inlet fitting 20 ' of FIG.
