Examples of 'inlet pipe' in a sentence
Meaning of "inlet pipe"
inlet pipe - a pipe or conduit that allows fluid to flow into a container or system
How to use "inlet pipe" in a sentence
Basic
Advanced
inlet pipe
Disconnect gas line to the inlet pipe.
Reconnect the water inlet pipe to the water valve.
The vacuum gauge installed in the inlet pipe.
Inlet pipe needs replacing.
Set the rubber hose on the connector of inlet pipe.
An inlet pipe provides fluid to the filter block chamber.
The exterior wall duct with telescopic inlet pipe.
Inlet pipe for air with oxidising or reductive properties.
Connect the other end of inlet pipe to the inlet.
Flexible pipe is not recommended on suction pipe inlet pipe.
The inlet stream is routed vÃa an inlet pipe to a separator vessel.
Priming time is proportional to the amount of air in inlet pipe.
It should be connected to the inlet pipe at the rear of the unit.
Inlet pipe if cast separately from the carburettor or cylinder or crankcase.
This makes the layout of the inlet pipe compact.
See also
Unscrew the inlet pipe from the backside of the machine.
We also suggest installing a cartridge filter on the water inlet pipe.
Install a foot valve on inlet pipe and lower into water.
The inlet pipe may be disposed so as to be inclined forward and downward.
Install a screen around the inlet pipe to prevent entrapment of swimmers.
Inlet pipe is not tightly screwed to the machine or to the water faucet.
Connect the water inlet pipe with the valve again.
The machine has a check valve located in the water inlet pipe.
Coolant inlet pipe.
These deflector means may be made up of the shape of the inlet pipe.
The threaded inlet pipe supports the filter cartridge during use.
There is provided at least one water inlet pipe on the cap.
An inlet pipe for the polyisocyanate composition in contact with the blocking agent.
The filtration modules are connected to an inlet pipe and to an outlet pipe.
The inlet pipe and the outlet pipe are disposed perpendicularly to each other.
Use a pipe dope compound to seal the inlet pipe thread connection.
Testing has shown that an important parameter is the dimensioning of the inlet pipe.
Install a foot valve on the inlet pipe and lower into the water.
A tube for drawing up said liquid is placed on the liquid inlet pipe.
The air supply to the air inlet pipe is described more fully below.
Water can be drained from the pump through the boiler inlet pipe.
Connect the raw water supply to the inlet pipe connection of the yoke.
The label must be placed as close as possible to the dryer gas inlet pipe.
The mixing device comprises a water inlet pipe and an air inlet pipe.
Water can be drained from the heater through the boiler inlet pipe.
Take the whole and slide the inlet pipe into the wall opening.
The cooling air discharge pipe surrounds the hot air inlet pipe.
The inlet pipe extended by the inlet chamber is formed within the inlet body.
Remove any water from the water inlet pipe and the valve.
A second alternative to a traditional flow switch is a pressure sensor mounted in the water inlet pipe.
Connect the cold water inlet pipe to the inlet tapping marked with a blue ring.
Water from the heater is drained through the inlet pipe of the heater.
A feed inlet pipe communicates tangentially with the separation chamber which contains a tubular vortex finder.
The mass flowmeter does not require any flow conditioning or straight inlet pipe sections.
The dust accumulated inside the inlet pipe can eventually limit the flow of air.
You'll also be interested in:
Examples of using Pipe
Show more
Pressure transmission pipe in the combustion chamber
Pipe is the heaviest wave in the world
Two pieces of pipe and a bicycle chain
Examples of using Inlet
Show more
Attach inlet and discharge hoses to pump
Check and clean inlet hose screen
Place inlet hoses inside washer basket
