Examples of 'interrupt request' in a sentence
Meaning of "interrupt request"
interrupt request: A signal in computing that is sent to the CPU (Central Processing Unit) to request its attention or action. It is used by devices to notify the CPU that they require immediate service or communication
Show more definitions
- The act of interrupting any of several hardware processes in a computer.
How to use "interrupt request" in a sentence
Basic
Advanced
interrupt request
The interrupt request may be sent at any time.
They are also a source of interrupt request from the controller.
This event is called trigger and causes an interrupt request.
The interrupt request is latched immediately following the falling edge of.
This signal is also suppressed if there had been no interrupt request.
A one indicates an interrupt request for its respective comparator output.
One of the devices which are connected to the interrupt request line.
This interrupt request is referred to as the qualification interrupt request or first interrupt signal.
Clearing the enable with an interrupt pending will remove the interrupt request.
The interrupt request is a request for activating the serial peripheral interfaz of the fingerprint sensor.
A disabled interrupt simply means the processor ignores any new interrupt request signal.
Bit 2 ask for an interrupt request at the end of.
The act of initiating a hardware interrupt is referred to as an interrupt request IRQ.
The external register IRR interrupt request register contains,.
FIQ mode: A privileged mode that is entered whenever the processor accepts a fast interrupt request.
See also
When a capture is made, an interrupt request flag is set.
The interrupt request is received by the master device 10.
An attempt to execute it at level 5 would result in an interrupt request at level 1.
The transmission conditions for an interrupt request from the LSSCI interface are thus genuinely re-created.
When a one is written into a command bit, the corresponding interrupt request is cleared.
Your PC must have a unique interrupt request ( IRQ ) available to the touch sensor.
Each hardware device communicates to other devices through an interrupt request channel ( IRQ ).
There are therefore only 15 interrupt request lines available for hardware.
FIG . 5 illustrates the external registers which are utilized in the interrupt request procedure.
Interrupt request line ( IRQ ) used by the modem.
Unable to open a device that was sharing an interrupt request ( IRQ ) with other devices.
The interrupt request level ( IRQL ) is the priority of an interrupt request.
Interrupts are allowed in control register management, and interrupt request is recorded in PWM INT register.
An interrupt request IT is then dispatched to a module 14 termed the " IT vectorization module ".
This error message is generated when there is a problem with Interrupt request ( IRQ ) translation.
The IRQ, abbreviation of interrupt request line and pronounced I-R-Q, are hardware lines over which.
The arrival of an ENI synchronization signal generates an interrupt request signal INTR1 *.
INTR2 * interrupt request transmitted by the operating state change request signals originating internally ;.
Upon reception of the page, the DVT generates the interrupt request signal IRQ.
If the interrupt request IRQ1 is input, the LSTART routine is started again.
LSMI, System management interrupt request.
The interrupt request must be present at least 125 ns in edge-triggered mode.
Microprocessor 1 is advised of this signal, through an interrupt request.
Generate an interrupt request to the CPU32.
The routine starts at step 50 in response to an interrupt request.
The CPU 22 may also receive an interrupt request signal from the UART 38.
If possible, use the Serial Communication port that uses Interrupt Request 3.
The ICH2 has eight programmable interrupt request ( PIRQ ) input signals.
At a time 718, the second slave device may decide to initiate an interrupt request.
The interrupt signal 300 remains high until the next interrupt request in the next message frame.
One unassigned line of the S-100 bus then was reassigned to support the non-maskable interrupt request.
Issuing a level-2 interrupt request.
These signals are grouped together to supply an interrupt request signal INTR2 *.
Clearing ICSR [ 2 ] will reset the interrupt request.
You'll also be interested in:
Examples of using Interrupt
Show more
We interrupt this program for a special announcement
You will have to interrupt him to do that
We interrupt this program with an important announcement
Examples of using Request
Show more
Request for the inclusion of a supplementary item
Parties may wish to request the secretariat to
Your request is treated uniquely and professionally
