Examples of 'joints must' in a sentence
Meaning of "joints must"
Joints must is an incomplete phrase that requires additional context or completion to convey its intended meaning. It could be part of a sentence referring to certain requirements, actions, or conditions related to joints, which could have various interpretations depending on the specific context. Without further information, it is difficult to determine the precise meaning and usage of this phrase
How to use "joints must" in a sentence
Basic
Advanced
joints must
Joints must be secured with duct tape.
Damaged flexibles or flexible joints must be replaced.
Drain joints must be insulated to avoid water leaks.
The thread of threaded joints must not be damaged.
All joints must be tightly sealed to avoid leaks.
The simply constructed joints must have broken.
Drain joints must be insulated so as to avoid water leaks.
This means that the joints must be well made.
All joints must be backed by timber.
It is also important to know that the joints must be completely sealed.
The solder joints must not be damaged by vibrations.
Damaged seals and their corresponding potentially damaged ball joints must be replaced.
All bolts at joints must be adequately protected.
For multi-layer constructions staggered joints must be provided for.
These joints must run a fortune.
See also
In the most severe cases, affected joints must be surgically replaced.
The joints must be properly sealed.
After a sporting effort, the muscles and joints must rest.
Grout joints must remain full.
For maximum efficiency, all enclosure wall joints must be tight fitting.
Joints must not be weak points.
All vent connector joints must be sealed and fastened.
Joints must be clean for the mortar to stick properly.
Sealant on all pipe joints must be resistive to LP gas.
All joints must be checked for gas tightness after installation.
To prevent such cracks, contraction joints must be installed at appropriate intervals.
Rail joints must not be placed in road crossings if possible.
All gears, bearings and moving joints must be greased or oiled carefully.
Only joints must be detected if necessary.
Flaws and defects must be repaired to a professional standard, bearings and joints must be lubricated.
All vertical joints must be supported on timber studs.
At the same time, the soldered and crimped electrical joints must be completely secure.
These joints must proceed through the tile work.
To move the endoscope, the pneumatic powered joints must be initially released into a relaxed condition.
The joints must be carried out as carefully as possible and not be evident.
The movement of the sliding knee joints must not exceed 15 mm.
All joints must be sealed.
WARNING-Internal duct joints must be.
The joints must be strong.
The universal joints must turn freely on the push rod.
Joints must be.
Directional Ball Joint Some ball joints must be installed in a specific orientation to function correctly.
Joints must be air - and watertight.
In any event, all joints must be considered in the design.
Joints must be airand water-tight.
To be considered JIA, the joints must have swelling and pain for at least 6 weeks.
Joints must be air-tight and water-tight.
The soldering joints must always be clean and grease-free.
The joints must be glued so they are watertight and resist root penetration.
The more weight your joints must bear, the more strain and damage they will receive.
