Examples of 'leds blink' in a sentence
Meaning of "leds blink"
leds blink - It describes the action of light-emitting diodes (LEDs) turning on and off rapidly, typically in a repeated pattern, as a visual indication or signal
How to use "leds blink" in a sentence
Basic
Advanced
leds blink
The LEDs blink red three times.
All indicator lights and display segment LEDs blink.
Red and blue LEDs blink alternately.
Connect the speakers and wait until the LEDs blink in blue.
The LEDs blink in orange three times.
During charging all LEDs blink at the same time.
Right and Left print cartridge LEDs blink.
Power and Ready LEDs blink at the same tempo.
Headset and base not paired-All LEDs blink.
Red and blue LEDs blink alternately Pairing mode.
Li ion battery charge status LEDs light constantly LEDs blink Charge status C.
Both leDs blink alternatively . les voyants clignoteront en alternance.
Power and Ready LEDs blink alternately.
The power tool does not run and all 4 LEDs blink.
All 3 LEDs blink when the device is fully charged.
See also
When you press the disarm button, all three LEDs blink slowly.
The green and the red LEDs blink alternately for 2 seconds.
Turning the knob to program the cooking time, the two leds blink.
When the power LEDs blink red, there is too little water in the tank.
When the drone is connecting to the controller, the front blue LEDs blink.
For incompatible drives, the hard drive LEDs blink red rapidly as the unit powers up.
The LEDs blink alternately, during the programming stage this means that the memory is full.
Show recording state, The camera LEDs blink if an event occurs and recording takes place.
Note, LEDs blink synchronously The panel lights the error led and displays the error code.
Right transmitters fails, the LEDs blink red 5 times.
After the LEDs blink in sequence, release the MAN key.
After 120 hours of motor operation, the charcoal filter alarm is activated all the LEDs blink.
If occupancy indicator LEDs blink together every few seconds, sensor is using Light Level feature.
Push the Configuration key on one of your speakers . > The LEDs blink rapidly.
When the LEDs blink once and the Wizard vibrates once, release the Power button.
The 3 LEDs blink until the command is registered at the system, then.
Note, the LEDs blink for 6 seconds after setting the steering angle.
