Examples of 'locking nuts' in a sentence
Meaning of "locking nuts"
locking nuts: This phrase describes specialized nuts with built-in mechanisms designed to prevent them from loosening or coming undone, often used in automotive and mechanical applications
How to use "locking nuts" in a sentence
Basic
Advanced
locking nuts
Loosen locking nuts with a hex wrench.
After two days tighten up the locking nuts.
Tighten locking nuts securely with the wrench.
Then tighten the locking nuts.
Tighten both locking nuts and motor mount nuts.
Be careful not to over tighten the locking nuts.
Locking nuts screwed completely onto the tension bar.
Secure with the locking nuts.
Loosen the locking nuts on the support roller cover.
Securethe VibrationMountsto the FrameFootwith the included locking nuts.
Tighten the locking nuts on the support roller guard.
In this configuration the upper race comprises conventional ball bearings with adjustment and locking nuts.
Screws with locking nuts.
Place brass locking nuts and ferrules as shown in the diagram.
Thread through the carriage bolts from underneath and secure with the locking nuts U.
See also
Loosen the leveling locking nuts and install the vinyl feet.
Repeat the adjustment for each of the other 3 adjuster screws and locking nuts.
Tighten the locking nuts in the order depicted in the image above.
To minimize vibration, the locking nuts must.
Carefully tighten the locking nuts while holding the leveling screws stationary.
Attach the rear support to the frame with two bolts, washers and locking nuts.
Tighten the two set screws and locking nuts in the downrod support.
Tighten the locking nuts while holding the leveling screws so they do not rotate.
To minimize vibration, the locking nuts must be tight.
Self locking nuts should only be used once and should be replaced after single use.
Pulling out and drawing back design, use the right length by free locking nuts.
An elbow connector with locking nuts assures fixation of both shafts and prevent further sliding.
Once the distance and inclination are set how you want, tighten the locking nuts carefully.
KMT locking nuts with locking pins.
These means may consist of screws or locking nuts 45.
Spikes, locking nuts and adjusting spanner.
Use a 17mm cone wrench to hold the axle locking nuts in place.
Locking nuts 135 are used on all of the screws in the switch section.
When your washer is level, tighten the locking nuts using the wrench or ( - ) flathead screwdriver.
Besides its sealing function, mass 114 performs an additional function of locking inside locking nuts 12.
Tighten the locking nuts evenly, until the specified adjustment dimension “ Y ” has been reached.
Finally, the bolts 16 and the locking nuts are tightened.
Adjust locking nuts to allow Pointer ( A ) to pivot freely.
When platform and fl ipover are fl ush, torque both locking nuts to 192 lb-ft.
Tuner locking nuts Images & Photos.
And the latter being associated with locking nuts 336 Fig.
RODOGRIP- locking nuts.
Reached, and then tighten the pressure pad screws (Fig. 5 H) in the locking nuts.
You'll also be interested in:
Examples of using Nuts
Show more
Soak nuts and seeds before blending
Tighten the small nuts with a spanner
Place nuts in recessed areas on front of handle
Examples of using Locking
Show more
I am not locking the dog in the kitchen
Cylinder locks with custom locking system
A sturdy locking mechanism secures the displays
