Examples of 'locknuts' in a sentence
Meaning of "locknuts"
locknuts (noun) - mechanical devices used to secure bolts by preventing them from loosening under vibration or torque
Show more definitions
- plural of locknut
How to use "locknuts" in a sentence
Basic
Advanced
locknuts
Tighten locknuts and test on a piece of plywood.
Repeat for the other locknuts.
The locknuts must be tightened to prevent vibration.
Check that the locknuts are tightened.
Loosen the gear shift linkage rod locknuts.
Adjust locknuts according to freedom of caster swing.
Tighten the linkage rod locknuts.
All four locknuts on the feet must be tightened.
Securely tighten all locknuts by hand.
Tighten the locknuts to lock the support feet.
Theft is prevented by means of special locknuts.
Do not move the locknuts of the threaded rod.
Plug any holes in mower with bolts and locknuts.
Securely tighten the locknuts onto the threaded studs.
The ends of the cable are attached with locknuts.
See also
The use of locknuts or bushings are to be connected to the side.
The washing machine s leveling feet should be minimized and turn the locknuts counterclockwise to secure.
Timken offers a wide range of locknuts to locate bearing assemblies on application shafts.
Install extension bracket and lever assembly onto coin slide bracket using two screws and locknuts.
For undercounter installations the locknuts may need to be removed before installing.
Standard locknuts or bushings shall not be used for the bonding required by this section.
Noise and vibration may result if Locknuts are not tightened.
Tighten the locknuts against the clevises when the settings are correct.
MS series are mounted on metric shafts sizes with HM locknuts.
Loosen the locknuts and adjust legs by screwing into or out of unit base.
Check that the compressor 's locknuts are tightened.
Loosen the locknuts and adjust legs by screwing into or out of washer base.
Mm open-end wrench for leveling leg locknuts.
Tighten the locknuts while holding the screw stationary in its correctly adjusted position.
Used to store spare shear bolts, locknuts and wrench.
Loosen all the locknuts of the anchor bolts and levelling screws and slightly tighten.
Once done, fix the feet in place with the locknuts provided.
Loosen but do not remove the locknuts and screws on the other two flange keepers.
The washer 's leveling feet should be fully retracted and locked into position with the locknuts.
Remove the two flat screws and locknuts that secure footplate to the half clamp.
Tighten locknuts up to washer base, or washer will move out of position during operation.
For pedestal installations, remove the locknuts from each of the washer legs.
If these locknuts are not tight, unit will move out of position during operation.
Using standard tools, our one-piece locknuts will ease installation and maintenance.
Remove 4 locknuts on the motor side of the blower and remove the bracket.
Then secure the gearmotor onto the foundation plate, tightening the two locknuts fully down.
UL listed wire locknuts are included in installation kit.
Installation is very easy through use of double sided 3M tape and 2 screws with locknuts.
Loosen the locknuts on the PTO adjustment linkage.
Raise Lower Tighten all 4 locknuts securely.
If these locknuts are not tight, washer will not remain stationary during operation.
Remove hubcaps, locknuts and washers.
Loosen locknuts for engine hold-down bolts only until washers beneath.
Once the adjustment has been made, tighten the locknuts 3.
If the locknuts are not tight, washer will move out of position during operation.
