Examples of 'measure voltage' in a sentence
Meaning of "measure voltage"
measure voltage: Involves determining the electrical potential difference between two points in a circuit. This is commonly done using a voltmeter to ensure the proper functioning of electrical systems
How to use "measure voltage" in a sentence
Basic
Advanced
measure voltage
Do not measure voltage when the.
Apply test leads to the circuit to be tested to measure voltage.
Do not measure voltage or current in humid or wet environment.
They do not measure voltage.
Measure voltage across batteries.
Temperature sensors measure voltage and current that is delivered.
The voltmeter can be multiplexed to alternately measure voltage and current.
Do not measure voltage while in resistance.
Partial disassembly and special tools are required to accurately measure voltage output and frequency.
If you measure voltage the aperage terminals must not be connected.
Most electricity meters mainly measure voltage and energy consumption.
They measure voltage and amperage peaks and average them.
First, configure the multimeter to measure voltage.
The microcontroller is programmable to measure voltage inputs as required by the particular application.
Measure voltage 5 seconds after the gas valve opens clearly audible noise.
See also
Use high voltage probe to measure voltage at collecting cell ionizer or cell plates.
Measure voltage across terminals on relay RL2 ( heater relay ) on electronic control.
Volt and amp meters were connected to measure voltage and current consumption, respectively.
To measure voltage and current to exhaust fan motor Type, clamp-on.
The predefined event condition is illustrated in FIG . 2 by a drop 21 in the measure voltage.
Monitor engineering equipment, measure voltage and power consumption, measure for chemical substances and more.
Another alternative for monitoring partial filling is to just measure voltage 14B, 20.
Reconnect power and measure voltage drop between terminal COM on relay RL2 and neutral.
Measure voltage at the terminal point ( 2 ) and adjust it.
The regulation loop 4 serves to measure voltage between the impedances 11 and 12 and the sensor 6.
Never measure voltage if the voltage on the terminals exceed 1 000V above earth ground.
The voltage measuring component ( 303 ) may also measure voltage changes to calculate a Thévenin resistance.
If you want to measure voltage of Channel 1, you can do as the follows.
You'll also be interested in:
Examples of using Measure
Show more
It was an emergency measure but overcrowding is still a problem
Measure the difference between the markings
The unit of measure for water pressure
Examples of using Voltage
Show more
Voltage drop due to use of extension cable
Information on the voltage is on the rating plate
Voltage measure switch for phase voltage
